522179
29
Zoom out
Zoom in
Previous page
1/44
Next page
22
3. INITIAL SETTINGS, OPERATION
3.1 Selecting the Transmission Power
The default transmission power is 600 W. If the 1 kW transducer is installed, turn on
the #1 segment of DIP SW S2 on the pcb 02P6353 inside the network sounder.
For NavNet/NavNet vx2
1. Detach the power cable.
2. Detach the cover of the DFF1; grasp the cover at opposing sides with hands, pull
outward slightly and lift up to detach.
3. Loosen three screws fixing the inside cover, and slide cover forward to detach it.
4. Set the #1 segment of DIP SW S2 according to transducer connected.
PCB 02P6353
5. Close the inside and outside covers and connect the power cable.
For NavNet 3D/TZtouch: Set the transducer type at the NavNet 3D/TZtouch. See re-
spective installation manual for the procedure.
WARNING
Do not open the equipment
unless totally familiar with
electrical circuits and
service manual.
Only qualified personnel
should work inside the
equipment.
1 kW transducer
LAN connector
S2
02P6353
OFF
ON
4 3 2 1
600 kW transducer
OFF
ON
4 3 2 1
J17
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno DFF1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno DFF1 in the language / languages: English as an attachment in your email.

The manual is 2,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info