522179
15
Zoom out
Zoom in
Previous page
1/44
Next page
8
1.5 Inside Hull Mount
This mounting method is available for FRP boats.
1.5.1 Necessary tools
You will need the following tools:
Sandpaper (#100)
Silicone sealant
Silicone grease
1.5.2 Remarks on installation
Turn off the engine and anchor the boat while installing the equipment.
Install the transducer in the engine room.
1.5.3 Mounting location
Keep the following points in mind when selecting a mounting location:
The mounting location should be where the hull is of single-hull thickness and is
void of air or flotation materials other than solid fiberglass between the transducer
face and the water.
Do not place the transducer over hull struts or ribs which run under the hull.
Avoid a location where the rising angle of the hull exceeds 15°, to minimize the
effect of the boat's rolling.
You will finalize the mounting location through some trial and error. The procedure
for this is shown later.
Inside-hull transducer mounting location
50cm
50cm
15cm
15cm
1/3
1/2
Mounting location
for transducer
Center line
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno DFF1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno DFF1 in the language / languages: English as an attachment in your email.

The manual is 2,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info