522183
23
Zoom out
Zoom in
Previous page
1/40
Next page
2. WIRING
15
12. Transducer cable: Lay the transducer cable in the cable clamp then refasten the clamp fixing
plate.
Cable for the external KP: Lay the cable in the cable clamp and fix it with the supplied clamp
fixing plate and two upset screws.
13. Connect the cables as follows:
Transducer cable: See section 2.2.2.
Cable for external KP: See the illustration below. Pass the cable through the edge saddle
and connect the cable to J12 on the PWRTX board. Be sure the cable does not contact TB4.
Note: For cable MPYC-2, tape the vinyl sheath of the cable (approx. 6 to 7 turns) where it lies
in the cable clamp and fasten the cable clamp. The PH connector has two unused harnesses.
Cut them at their base or wrap them with vinyl tape.
Lock nut for super gland (2 pcs.)
Clamp fixing plate
Large: transducer cable
Small: cable for external KP
Edge saddle
J12
Lay vinyl sheath in
cable clamp and
fasten clamp fixing
plate (supplied).
(See step 11.)
Be sure cable does
not contact TB4.
Taping.
Cut off two unused
harnesses at base.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno DFF1-UHD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno DFF1-UHD in the language / languages: English as an attachment in your email.

The manual is 12,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info