28260
46
Zoom out
Zoom in
Previous page
1/63
Next page
35
Magnetron heater voltage
Magnetron heater voltage is formed at the MD
Board of the antenna unit and preadjusted at
the factory for use with any length of signal
cable. Therefore no adjustment is required.
However, verify heater voltage by following
the procedure below.
1. Turn on the radar (if it is not already on)
and set it in stand-by.
2. Open the antenna housing (radome) cover.
Connect a multitester, set to 10 V DC range.
3. Close the antenna housing cover and tighten
the fixing bolts.
Setting a blanking area
When the antenna is installed at a close dis-
tance in front of the wheelhouse, the radar
should be set not to transmit within that area.
No echoes appear in the blanking areas.
1. Select "7. Dead Sector".
2. Press the [ENTER] key.
3. Operate the omnipad to enter starting point
of area (in figures).
4. Press the [ENTER] key.
5. Operate the omnipad to enter ending point
of area (in figures).
6. Press the [ENTER] key.
Area of no
transmission
Figure 6-27 Blank areas where
transmission is suspended
This area can be turned on/off on the OTHER
MENU. For detail, see the description on page
18.
Note: This setting should be done after other
adjustments are finished.
Model Check Point Rating Adjustment
point
M1832 TP802 #4, #6 on
PTU Board
7.4~7.6V R106
M1932 TP803 #4, #6 on
MD Board
7.4~7.6V VR801
M1942 TP803 #4, #6 on
MD Board
7.5~7.7V VR801
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno 1832 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno 1832 in the language / languages: English as an attachment in your email.

The manual is 1,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Furuno 1832

Furuno 1832 User Manual - Spanish - 53 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info