Manual Furuno 1824C (page 16 of 239) (English)

28254

Zoom out

Zoom in

1/239

1. OPERATIONAL OVERVIEW

1-5

1.3 Turning the Unit On/Off

Press the POWER/BRILL key to turn the unit on. A beep sounds and then the equipment

shows the startup NavNet screen (about 20 seconds), the product information screen,

startup test results and chart usage disclaimer. During this period the equipment is

inoperative. The startup test checks the ROM, RAM, internal battery and backup data for

proper operation, displaying the results for each as OK or NG (No Good). If NG appears an

appropriate message appears on the screen. For any NG, try to press any key to go to the

chart disclaimer screen, then perform the diagnostic test as shown in the paragraph “8.8

Diagnostics.”

For start up with the radar display, the magnetron takes from one minute and thirty

seconds to three minutes (depending on radar model) to warm up before the radar can be

operated. The time remaining for warming up of the magnetron is counted down at the

center of the display.

You may press any key at the chart disclaimer screen to show the last-used display, or wait

several seconds to let the equipment do it for you.

To turn the unit off, press and hold down the POWER/BRILL key until the screen goes off

(approx. 3 sec.). To protect the LCD attach the hard cover. Note that the network sounder

will be turned off approx. three minutes after turning off the power. This is due to the

system’s electrical characteristics.

Note: The first time you turn on the power (or any time the power is applied after a memory

reset), you are asked if you want to start the simulation mode, which provides simulated

operation of the equipment after the installation mode selection. Push the ENTER knob to

start the simulation mode, or press the CLEAR key to start normal operation. For further

details about the simulation mode, see the paragraph “1.10 Simulation Display.”

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Furuno 1824C in the language / languages: English as an attachment in your email.

The manual is 5,89 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Furuno 1824C

Furuno 1824C User Manual - Spanish - 241 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Furuno 1824C Manual

Product: