28240

Furuno 1742 Manual

145
Zoom out
Zoom in
Previous page
1/260
Next page
3. PLOTTER OPERATION
3-61
3.13 Entering the MOB Mark, Setting MOB as
Destination
The MOB (Man Overboard) mark functions to mark man overboard position. You
can inscribe this mark from any mode, except while playing back data or
conducting a self-test. Note that this function requires position data.
Man
overboad
Range, bearing
Current
position
MOB
mark
MOB Data Box
Bearing and range
to MOB position
M
(MOB)
M
O
B
162.5°
0.49 nm
MOB concept
1. Press and hold down the [SAVE/MOB] key for about three seconds when
someone falls onboard. The display shows the waypoint number being saved
(youngest empty waypoint number, 001-999) followed by the MOB
confirmation window.
Time remaining is counted down while pressing the [SAVE/MOB] key.
MAN OVER BOARD!
GO TO MOB?
YES ... PUSH ENTER KNOB
NO ... PUSH CLEAR KEY
WAYPOINT SAVED!
XXXWPT
CONTINUE PUSHING
FOR MOB!
XXX = Waypoint number
CONTINUE PUSHING
FOR MOB!
XX SEC
XX = Time remaining is counted down.
MOB mark messages
2. Push the [ENTER] knob to select the MOB position as the destination, or
press the [CLEAR] key to only mark current ship’s position as a waypoint. If
you select the MOB position as destination;
• A full-screen radar, plotter or overlay (color model only) appears depending on
the display in use.
• The MOB mark “M” appears at the MOB position and a line runs between it
and current position. This line shows the shortest course to the MOB position.
• Range and bearing to the MOB position are shown in the MOB data box.
To erase an MOB mark from the plotter display, you must first erase its
corresponding waypoint because that there are normal waypoint and MOB mark
at the same position. Place the cursor on the MOB mark, then press the
[CLEAR] key followed by pushing the [ENTER] knob to erase the waypoint. Then,
repeat to erase the MOB mark.
… 145 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno 1742 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno 1742 in the language / languages: English as an attachment in your email.

The manual is 3,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info