596216
25
Zoom out
Zoom in
Previous page
1/35
Next page
17
Shadow sectors
Funnels, stacks, masts, or derricks in the path of
the antenna block the radar beam. If the angle
subtended at the antenna is more than a few
degrees, a non-detecting sector may be
produced. Within this sector targets can not be
detected.
Radar
antenna
Radar
mast
Shadow sector
Figure 2-5 Shadow sectors
2.3 SART (Search and Rescue
Transponder)
Note: The SART information below is excerpted
from IMO SN/Circ 197 Operation of Marine
Radar for SART Detection.
A Search and Rescue Transponder (SART)
may be triggered by any X-Band (3 cm) radar
within a range of approximately 8 nm. Each
radar pulse received causes it to transmit a
response which is swept repetitively across the
complete radar frequency band. When
interrogated, it first sweeps rapidly (0.4 µs)
through the band before beginning a relatively
slow sweep (7.5 µs) through the band back to
the starting frequency. This process is repeated
for a total of twelve complete cycles. At some
point in each sweep, the SART frequency will
match that of the interrogating radar and be
within the pass band of the radar receiver. If the
SART is within range, the frequency match
during each of the 12 slow sweeps will produce
a response on the radar display, thus a line of
12 dots equally spaced by about 0.64 nautical
miles will be shown.
When the range to the SART is reduced to
about 1 nm, the radar display may show also the
12 responses generated during the fast sweeps.
These additional dot responses, which also are
equally spaced by 0.64 nm, will be interspersed
with the original line of 12 dots. They will appear
slightly weaker and smaller than the original
dots.
9500 MHz
9200 MHz
Radar antenna
beamwidth
Screen A: When SART
is distant Screen B: When SART
is close
Lines of 12 dots
are displayed in
concentric arcs.
Echo of SART
Position of
SART
Own ship's
position Own ship's
position
SART mark
length
Radar receiver
bandwidth
Sweep time
7.5 µs 95 µs
Sweep start High speed sweep signal
Low speed sweep signal
24 NM 1.5 NM
Position of
SART
Echo of
SART
Figure 2-6 Appearance of SART signal
on the radar display
General procedure for detecting
SART response
1. Use the range scale of 6 or 12 nm as the
spacing between the SART responses is
about 0.6 nm (1125 m) to distinguish the
SART.
2. Turn off the automatic clutter suppression.
3. Turn off the Interference Rejector.
General remarks on receiving SART
SART range errors
When responses from only the 12 low frequency
sweeps are visible (when the SART is at a
range greater than about 1 nm), the position at
which the first dot is displayed may be as much
as 0.64 nm beyond the true position of the
SART. When the range closes so that the fast
sweep responses are seen also, the first of
these will be no more than 150 meters beyond
the true position.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno 1622 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno 1622 in the language / languages: English as an attachment in your email.

The manual is 0,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Furuno 1622

Furuno 1622 Installation Guide - English - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info