596216
8
Zoom out
Zoom in
Previous page
1/24
Next page
2
4. Using the hex bolts, flat washers and spring
washers removed at step 1, fasten the base
to the platform.
The torque should be
between 19.6-24.5 N
m.
Note:
Longer hex bolts (M10X25) are
supplied with the installation materials. Use
them instead of the hex bolts removed
earlier if the mounting platform is very thick.
Flat
washer
Antenna base
assy.
Spring
washer
Platform
Hex bolt
(M10 x 25
or M10 x 20)
Transceiver
module
5-10
mm
Figure 4 How to fasten the base to platform
5. Unfasten the cable of the rotation detector
from the cable clamp.
Cable clamp
Rotation detector
Caution
Figure 5 Antenna unit, inside view
Caution: Be careful not to pinch the
rotation detector cable when remounting
the shield plate.
6. Unfasten 11 screws to dismount the shield
plate.
Shield Plate
Discard screw
marked with .
Figure 6 Antenna unit, inside view
7. Pass the antenna cable with connector
through the gasket and cable clamp, and
then tighten cable gland.
Be sure the shrink tubing on the antenna
cable is not covered by the gasket.
Gasket
Cable Gland
Rubber
Gasket
Figure 7 Antenna unit, inside view
8. Referring to Figure 8, fasten the shield
cable to a screw (M4x 10) on the chassis to
ground the unit.
Connect 9 pin
connector
here (J801).
Connect
shield here.
Figure 8 How to connect the antenna cable
to the antenna unit
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno 1622 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno 1622 in the language / languages: English as an attachment in your email.

The manual is 1,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Furuno 1622

Furuno 1622 User Manual - English - 35 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info