560262
27
Zoom out
Zoom in
Previous page
1/87
Next page
Using the Tablet PC
If you are replacing the battery, wait until system operation is suspended and the power
indicator is flashing before you remove the battery. Failure to do so could result in loss of
your unsaved data.
(Note: If the Resume On LAN function is enabled in the BIOS Setup, you should not remove
the battery unless the system has been shut down. When Resume ON LAN is enabled, the
buffer battery is disabled in order to optimise battery life.)
!
The power indicator either flashes (Suspend-to-RAM) or is not displayed (Hibernate) when
system operation is suspended, depending on how your system is configured. At this point,
programs that were running are stopped, active data is saved, and the system enters one
of two different low-power modes, or suspend modes, as explained in the following
paragraphs
Refer to the "Resuming operation" section in this chapter to resume system operation. Also, note the
following with regard to suspending system operation:
You can remove the battery while the system is in Suspend-to-RAM or Hibernate mode in order
to install a charged battery. To prevent losing unsaved data, wait until system operation has
been suspended before you remove the battery.
Note: After removing the battery, you have approximately five minutes to replace it with a new
battery or to plug in a power supply before the buffer battery is depleted.
Your system may be configured to suspend operation automatically after a period of inactivity.
If the battery charge drops to a Low Battery warning level while the system is running, the
system will beep periodically. If this happens, suspend system operation, shut down the
system, or connect an external power source, such as the mains adapter, to the Tablet PC.
If the battery charge drops to a critically low level while the system is running, the system is
forced into a pre-selected mode (Suspend-to-RAM or Hibernate). If this happens, you must
either install a charged battery, or connect an appropriate external power source such as the
mains adapter before you can resume system operation. If the battery charge drops to a
critically low level while the system is in Suspend-to-RAM mode, the system stays in Suspend-
to-RAM mode until power is restored or totally dissipated.
The suspend function on the On/Resume/Suspend button may be disabled to prevent
accidental interruption. If this is the case, pressing the On/Resume/Suspend button will not
suspend system operation as described here. (In this case, suspend mode can only be
activated using the system software.)
A26391-K222-Z121-1-7619, edition 2 19
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fujitsu STYLISTIC ST5112 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fujitsu STYLISTIC ST5112 in the language / languages: English as an attachment in your email.

The manual is 1,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fujitsu STYLISTIC ST5112

Fujitsu STYLISTIC ST5112 Quick start guide - German - 91 pages

Fujitsu STYLISTIC ST5112 Quick start guide - French - 87 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info