531674
11
Zoom out
Zoom in
Previous page
1/96
Next page
Safety, precautionary and compliance instructions
2
Electromagnetic compatibility
External units, such as monitors, joysticks, etc., may only be
connected to the interface ports with screened cables to meet the
harmonised standards under electromagnetic compatibility
(EMC) legislation.
You may only operate the unit if its rated voltage matches the
local mains voltage.
Information on R&TTE Directive
Fujitsu Siemens Computers hereby declares that the built-in
modem conforms to the fundamental requirements and the
relevant standards contained in the directive 1999/5/EC.
The complete original declaration of conformity for the R&TTE
Directive can be found in your PC’s electronic documentation.
Computer setup
Before you change, install or remove any components,
disconnect the mains plug and, if applicable, detach the
telephone cable from the PC (pull out the plug).
Before you open the housing, you must switch the PC off and
remove the plug from the socket. The proper operation
(according to IEC 60950/EN 60950) of the unit is only
guaranteed with a fully attached housing and covers for
installation slots ( electrical shock, cooling, fire prevention, noise
suppression).
Only authorised qualified personnel should open the unit.
Tampering with the unit will result in a loss of the right to
guarantee claims and the discontinuation of the manufacturer's
guarantee obligation to uphold the harmonised standards
according to the law regarding the electromagnetic compatibility
of units and low voltage directive.
All integrated circuits and memory modules, as well as the
contacts on all sockets and plugs, are susceptible to static
electricity. Protect these from static electricity. The effect of static
electricity, rapid transients or strong electromagnetic fields on the
unit may cause faults. When exchanging or installing a board or a
memory module, touch an earthed object or carry a ground strap
to divert any electrostatic charge from your body.
All ports are only designed for connection of safety extra-low
voltage (SELV).
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fujitsu-siemens Scaleo L at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fujitsu-siemens Scaleo L in the language / languages: English as an attachment in your email.

The manual is 4,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info