560211

Fujitsu-siemens fi-7160 Manual

196
Zoom out
Zoom in
Previous page
1/229
Next page
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
196
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
3 Select a detection method.
Method Description
None Does not detect multifeed.
Check
Overlapping
(Ultrasonic)
Detects multifeed by the overlapping of
documents.
When this is selected, you can also specify the
two following options:
z Specify the detection range by the length from
the top of the document.Proceed to
"Specifying the Area to Detect Multifeed
[Document check area specification for
Multifeed Detection]" (page 197) for more
details.
z Ignore the multifeed when there is paper of the
same size attached to a designated location
on the page.Proceed to
"Ignoring Multifeed for a Set Pattern" (page
103) for more details.
Check Length Detects multifeed by the difference in length of the
documents.
Note that multifeeds cannot be detected
accurately when scanning a mixed batch of
different sizes.
Check
Overlapping
and Length
Detects multifeed by the combination of [Check
Overlapping (Ultrasonic)] and [Check Length].
Note that multifeeds cannot be detected
accurately when scanning a mixed batch of
different sizes.
When this is selected, you can also specify the
two following options:
z Specify the detection range by the length from
the top of the document.Proceed to
"Specifying the Area to Detect Multifeed
[Document check area specification for
Multifeed Detection]" (page 197) for more
details.
z Ignore the multifeed when there is paper of the
same size attached to a designated location
on the page.Proceed to
"Ignoring Multifeed for a Set Pattern" (page
103) for more details.
Length Select a length difference from 10/15/20 mm. Any
length under the specified value will not be
detected as multifeed.
ATTENTION
z To scan documents with different lengths, specify [Check
Overlapping (Ultrasonic)].
z When an attachment such as a sticky note, receipt, or photo is
attached on the document, the overlapping part of the
document may be falsely detected as multifeed if [Check
Overlapping (Ultrasonic)] is specified. In that case, specify
[Check Length].
Note however that [Check Overlapping (Ultrasonic)] can still be
used by restricting the detection range.
z Multifeed cannot be detected when using the Carrier Sheet.
HINT
This setting can also be configured in the scanner driver.
Note that priority is given to the scanner driver setting.
Method Description
… 196 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fujitsu-siemens fi-7160 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fujitsu-siemens fi-7160 in the language / languages: English as an attachment in your email.

The manual is 16,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info