560211
47
Zoom out
Zoom in
Previous page
1/229
Next page
Contents
Index
Chapter 2 How to Load Documents
Appendix
Glossary
Introduction
TOP
47
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
How to Load
Documents
ATTENTION
z When you scan plastic cards, take note of the following.
- Up to three plastic cards can be loaded in the ADF paper chute
(feeder).
Note that you can only load one card at a time if the plastic card is
embossed.
- It is recommended to place the card face-down in the ADF paper
chute.
- Cards should be within the following specifications:
ISO7810 ID-1 type compliant
Size : 85.6 × 53.98 mm
Thickness : 1.4 mm or less (*1)
Material : PVC (polyvinyl chloride) or PVCA (polyvinyl chloride
acetate)
Make sure to check if the card can be scanned first.
*1: Up to 1.25 mm is supported for scanning at 300 dpi or less (80
ppm) in landscape when using the fi-7180/fi-7280.
This setting can be changed in the Software Operation Panel
to scan plastic cards with a thickness up to 1.4 mm.
For details, refer to "Scanning Thick Plastic Cards [Feed
Mode] (fi-7180/fi-7280)" (page 194).
- Rigid cards may not be fed properly.
- If the surface of the card is dirty with grease marks (e.g.
fingerprints) and such, perform scanning after wiping the dirt off.
- Plastic cards cannot be scanned when the imprinter is connected.
- Scanning thick documents such as plastic cards will be falsely
detected as multifeed.
In that case, to scan documents successfully, use the multifeed
window display function of the scanner driver, use the Intelligent
Multifeed function, or disable the multifeed detection.
BACK
HINT
z When scanning semi-transparent documents, increase the
brightness for scanning to avoid bleed-through.
z When you scan documents written in lead pencil, make sure to clean
the rollers frequently. Otherwise, the rollers will be contaminated
which may leave black traces on the document or cause feeding
errors.
For details, refer to "Chapter 6 Daily Care" (page 108).
z If multifeeds, pick errors or paper jams occur frequently, refer to "8.3
Troubleshooting" (page 137).
z When you scan documents with the ADF, all documents must be flat
on the leading edge. Make sure that curls on the leading edge of the
documents are kept within the following range.
30 mm or more
Feeding direction
3 mm
or less
5 mm
or less
30 mm or more
Feeding direction
(0.20 in.)
(0.12 in.)
(1.18 in.)
(1.18 in.)
Leading edgeLeading edge
Scanned side Scanned side
47


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fujitsu-siemens fi-7160 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fujitsu-siemens fi-7160 in the language / languages: English as an attachment in your email.

The manual is 16,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info