213035
43
Zoom out
Zoom in
Previous page
1/211
Next page
Contents
Index
Chapter 2 How to Load Documents
Appendix
Glossary
Introduction
TOP
43
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
How to Load
Documents
z When you scan plastic cards, take note of the following.
- Up to three plastic cards can be loaded in the ADF paper
chute.
Note that you can only load one card at a time if the
plastic card is embossed.
- It is recommended to place the card face-down in the
ADF paper chute.
- Cards should be within the following specifications:
ISO7810 ID-1 type compliant
Make sure to check if the card can be scanned first.
*1: Up to 1.25 mm is supported for scanning at 200 dpi (60
ppm) in landscape when using fi-6140Z/fi-6240Z. This
setting can be changed in the Software Operation Panel
to scan plastic cards with a thickness up to 1.4 mm. For
details, refer to " Scanning Thick Plastic Cards [Feed
Mode] (fi-6140Z/fi-6240Z)" (page 179).
- Rigid cards may not be fed properly.
- If the surface of the card is dirty with grease marks (e.g.
fingerprints) and such, perform scanning after wiping the
dirt off.
BACKBACK
Size : 85.6 × 53.98 mm
Thickness : 1.4 mm or less (*1)
Material : PVC (polyvinyl chloride) or PVCA (polyvinyl
chloride acetate)
- Plastic cards cannot be scanned when the imprinter is
connected.
- Scanning thick documents such as plastic cards will be
falsely detected as multifeed. In that case, disable
multifeed detection.
z When scanning semi-transparent documents, increase the
brightness for scanning to avoid bleed-through.
z When you scan documents written in lead pencil, make
sure to clean the rollers frequently. Otherwise, the rollers
will be contaminated which may leave black traces on the
document or cause feeding errors.
For details about cleaning, refer to "Chapter 6 Daily Care"
(page 108).
z If multifeeds, pick errors or paper jams occur frequently,
refer to "8.3 Troubleshooting" (page 130).
z When you scan documents with the ADF, all documents
must be flat on the leading edge. Make sure that curls on
the leading edge of the documents are kept within the
following range.
30 mm or more
Feeding direction
3 mm
or less
5 mm
or less
30 mm or more
Feeding direction
(0.20 in.)
(0.12 in.)
(1.18 in.)
(1.18 in.)
Leading edgeLeading edge
Scanned side Scanned side
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fujitsu-siemens fi 6130 sheet fed scanner at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fujitsu-siemens fi 6130 sheet fed scanner in the language / languages: English as an attachment in your email.

The manual is 18,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info