617569
33
Zoom out
Zoom in
Previous page
1/40
Next page
Removing and installing comp onents
during servicing
Removing and installing memory
modules
MainmemoryMemoryexpansionMemoryupgradeSysteme xpansion
The notebook will not start without memory modules, as no xed RAM is installed.
Your notebook supports dual-chann el DDR2 techn ology.
The dual-channel DDR2 technology can only be used with two identical
memory modules. When two different memory modules are installed, only
"single-channel" performance is supported.
If you are asked by the Hotline/Help Desk to remove and install the memory
modules yourself, proceed as follows:
Pay attention to the relevant safety notes provided in the "Important notes" chapter.
The notebook must be switched off when installing/removing the memory
modules, it must not be in Suspend mode.
Only use approved memory expansion modules in your notebook
(see Section "
Technical data", Page 28).
Never use f orce when installing or removing memory modules.
Make sure that foreign objects do not fall into the memory expansion compartment.
Individual components (e.g. the p
rocessor heat sink) can become very hot
during operation. Therefore, w
e recommend that you wait one hour after
switching off the notebook bef
ore removing or installing the memory modules.
Otherwise, there is a risk of su
ffering burns!
As some non-ESD safe component
s are exposed, please observe the section "
Notes
on installing and removing boa
rds and compon ents", Page 20.
Switch your notebook o ff and unplug the mains adapter from the mains outlet.
Close the LCD screen so that it locks into place.
Disconnect all cables connected to the notebook.
Turn your notebook over and place it on a stable, at and clean surf ace. If necessary, lay
an anti-slip cloth on t his surface to prevent the notebook from being scratched.
Remove the battery (see "
Removing the battery", Page 15).
A26391-K225-Z120-1-7619 , edition 1 25
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fujitsu LIFEBOOK E Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fujitsu LIFEBOOK E Series in the language / languages: English as an attachment in your email.

The manual is 2,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fujitsu LIFEBOOK E Series

Fujitsu LIFEBOOK E Series User Manual - German - 42 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info