Manual Fujifilm Finepix M 603 (page 42 of 45) (English)

101571

Zoom out

Zoom in

1/45

8382

Troubleshooting Possible causes Solutions

The camera does not

emit any sound.

i The camera volume is set too low.

i The microphone was blocked during

shooting/recording.

i There is something covering the speaker

during playback.

i Adjust the volume.

i Take care not to block the microphone

during shooting/recording.

i Ensure that the speaker is uncovered.

Frame erase does not

erase the frame.

The ERASE ALL

function does not erase

all the frames.

i DPOF settings are specified for some

frames.

i Some frames may be protected.

i Cancel the DPOF settings and try again

(➡P.50).

i Remove the protection.

There is no image or

sound on the TV.

i An A/V cable was connected during

movie playback.

i The camera is not connected to the TV

correctly.

i “TV” is selected as the TV input.

i The TV volume is turned down.

i Connect the camera and TV correctly.

i Set the TV input to “VIDEO”.

i Adjust the volume.

When the camera is

connected to a personal

computer (PC), the shot

image appears on the

camera’s LCD monitor.

i The special FinePix M603 USB cable is

not properly connected to the computer

or camera.

i The PC is not switched on.

i Set up the camera and the special

FinePix M603 USB cable correctly.

i Switch the PC on.

Nothing happens when I

use the camera

switches.

i Camera malfunction.

i The battery is exhausted.

i Briefly remove the battery or disconnect

the AC power adapter. Then reload the

battery or reconnect the AC power

adapter and try again.

i Load a fully charged battery.

The camera no longer

works correctly.

The camera has suffered an unforeseen

problem.

Briefly remove the battery or disconnect the

AC power adapter. Then reload the battery

or reconnect the AC power adapter and try

again.

I cannot shoot movies

continuously.

Is the “MOVIE RECORDING HAS

STOPPED CANNOT RESTART A WHILE”

warning displayed?

Switch the camera off and stop using it for

about 30 minutes until it has cooled down.

Note that you can still shoot still images

during this time.

Troubleshooting eIf you think the camera is faulty, check the following once more

Troubleshooting Possible causes Solutions

I tried to charge the

battery but the self-timer

lamp does not light.

i There is no battery in the camera.

i The camera and AC power adapter are

not connected correctly.

i Load the battery.

i Connect the camera and AC power

adapter correctly.

The self-timer lamp

flashes during charging

and I can’t charge the

battery.

i The battery terminals are dirty.

i The battery is faulty or flat.

i The slot cover is not closed properly.

i Take the battery out briefly and then

reload it.

i Wipe the battery terminals with a clean,

dry cloth.

i Fit a new battery. If the battery still fails to

charge, contact an authorized FUJIFILM

service center.

i Close the slot cover properly.

No power.

i The battery is exhausted.

i The AC power adapter plug has come

out of the power outlet.

i The battery is loaded the wrong way

round.

i The slot cover is not closed properly.

i Load a fully charged battery.

i Plug the adapter back in.

i Load the battery in the correct direction.

i Close the slot cover properly.

Power cuts out during

operation.

The battery is exhausted. Load a fully charged battery.

Battery runs out quickly.

i Camera is being used in extremely cold

conditions.

i The terminals are soiled.

i The battery is flat.

i Put the battery in your pocket or another

warm place to heat it and then load it into

the camera just before you take a picture.

i Wipe the battery terminals with a clean,

dry cloth.

i Load a fully charged battery.

No photograph is taken

when the shutter button

is pressed.

i No a media is loaded.

i The media is fully recorded.

i The media is not formatted.

i The xD-Picture Card contact area is

soiled.

i The media is damaged.

i The Auto Power Off function switched the

camera off.

i The battery is exhausted.

i Load a media.

i Insert a new media or erase some

unwanted frames.

i Format the media.

i Wipe the xD-Picture Card contact area

with a clean dry cloth.

i Load a new media.

i Switch the camera on.

i Load a fully charged battery.

I can’t use the flash to

take pictures.

i The shutter button was pressed while the

flash was charging.

i The Suppressed Flash mode is selected.

i Wait until charging is completed before

pressing the shutter button.

i Set the flash mode to Auto, Red-eye

Reduction or Forced Flash (The flash

cannot be used in some modes).

I can only select

“Suppressed Flash” flash

mode.

Continuous shooting is selected. Set continuous shooting to OFF.

I can only select the

“

” quality setting.

i The sensitivity is set to 800 or 1600

(high-sensitivity photography) in the

Photography menu.

i The continuous shooting option in the

photography menu is set to “MEGA

Continuous Shooting”.

i In the Photography menu, set the

sensitivity to 400 or less.

i Set the continuous shooting option to

something other than “MEGA Continuous

Shooting”.

The photographed

image is dark even

though I used the flash.

i The subject is too far away.

i Your finger was covering the flash/flash

control sensor.

i Move to within the effective flash range

before taking the shot.

i Hold the camera correctly.

The image is blurred.

i The lens is dirty.

i You photographed scenery with Macro

mode selected.

i You took a close-up shot without

selecting Macro mode.

i You are shooting a subject that is not

suited to autofocusing.

i Clean the lens.

i Cancel Macro mode.

i Select Macro mode.

i Use AF/AE lock to take the shot.

There is speckling on the

image.

The shot was taken with a slow shutter

speed (long exposure) in a high-

temperature environment.

This is a characteristic of CCDs and does

not indicate a camera fault.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Fujifilm Finepix M 603 in the language / languages: English as an attachment in your email.

The manual is 4,44 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Fujifilm Finepix M 603 Manual

Product: