101507
50
Zoom out
Zoom in
Previous page
1/55
Next page
9998
The image is blurred.
There is speckling on
the image.
The camera does not
emit any sound.
Frame erase does not
erase the frame.
The ERASE ALL
function does not erase
all the frames.
There is no image or
sound on the TV.
When the camera is
connected to a
computer, the
photography or playback
screen appears on the
cameras LCD monitor.
Nothing happens when
I use the camera
switches.
The camera no longer
works correctly.
i The lens is dirty.
i You photographed scenery with Macro
mode selected.
i You took a close-up shot without
selecting Macro mode.
i You are shooting a subject that is not
suited to autofocusing.
The shot was taken with a slow shutter
speed (long exposure) in a high-
temperature environment.
i The camera volume is set too low.
i The microphone was blocked during
shooting/recording.
i There is something covering the speaker
during playback.
Some frames may be protected.
i An A/V cable was connected during
movie playback.
i The camera is not connected to the TV
correctly.
i TV is selected as the TV input.
i The TV volume is turned down.
i The USB cable (included) is not properly
connected to the computer or camera.
i The PC is not switched on.
i Camera malfunction.
i The battery is exhausted.
The camera has suffered an unforeseen
problem.
i Clean the lens.
i Cancel Macro mode.
i Select Macro mode.
i Use AF/AE lock to take the shot.
This is a characteristic of CCDs and does
not indicate a camera fault.
i Adjust the volume.
i Take care not to block the microphone
during shooting/recording.
i Ensure that the speaker is uncovered.
Remove the protection.
i After the movie playback mode is
stopped, connect the camera and TV
correctly.
i Connect the camera and TV correctly.
i Set the TV input to VIDEO.
i Adjust the volume.
i Set up the camera and the USB cable
(included) correctly.
i Switch the PC on.
i Briefly remove the battery or disconnect
the AC power adapter. Then reload the
battery or reconnect the AC power
adapter and try again.
i Load a new fully charged battery.
Briefly remove the battery or disconnect
the AC power adapter. Then reload the
battery or reconnect the AC power adapter
and try again.
If the error message is still
displayed, contact your FUJIFILM dealer.
Troubleshooting Possible causes Solutions
Troubleshooting eIf you think the camera is faulty, check the following once more.
The self-timer lamp
does not light when
charging the battery.
The self-timer lamp
blinks during charging
and the battery wont
charge.
No power.
Power cuts out during
operation.
Battery runs out quickly.
No photograph is taken
when the Shutter button
is pressed.
Cant use the flash to
take pictures.
The flash settings are
restricted and cannot
be selected.
Can only select
Suppressed Flash
flash mode.
The
Q
or
5
quality
modes cannot be
selected.
The photographed
image is dark even
though the flash was
used.
i There is no battery in the camera.
i The camera and AC power adapter are
not connected correctly.
i The battery terminals are dirty.
i The battery is faulty or flat.
i The battery is exhausted.
i The AC power adapter plug has come
out of the power outlet.
i The battery is loaded the wrong way
round.
i The battery cover is not closed properly.
The battery is exhausted.
i Camera is being used in extremely cold
conditions.
i The terminals are soiled.
i The battery is flat.
i No xD-Picture Card is inserted.
i The xD-Picture Card is fully recorded.
i The xD-Picture Card is not formatted.
i The xD-Picture Card contact area is
soiled.
i The xD-Picture Card is damaged.
i The Auto Power Off function has
switched the camera off.
i The battery is exhausted.
i The Shutter button was pressed while
the flash was charging.
i The flash is not popped up.
i The camera is set to Scenery in Scene
Position mode.
i Continuous shooting is selected.
Scene Position mode is selected.
Continuous shooting is selected.
The sensitivity is set to 800 (high-sensitivity
shooting).
i The subject is too far away.
i Your finger was covering the flash/flash
control sensor.
i Load the battery.
i Connect the camera and AC power
adapter correctly.
i Take the battery out briefly and then
reload it.
i Wipe the battery terminals with a clean,
dry cloth.
i Fit a new battery. If the battery still fails
to charge, contact an authorized
FUJIFILM service center.
i Load a fully charged battery.
i Plug the adapter back in.
i Load the battery in the correct direction.
i Close the battery cover properly.
Load a new fully charged battery.
i Put the battery in your pocket or another
warm place to heat it and then load it
into the camera just before you take a
picture.
i Wipe the battery terminals with a clean,
dry cloth.
i Fit a new battery.
i Insert an xD-Picture Card.
i Insert a new xD-Picture Card or erase
some unwanted frames.
i Format the xD-Picture Card.
i Wipe the xD-Picture Card contact area
with a clean dry cloth.
i Insert a new xD-Picture Card.
i Switch the camera on.
i Load a new fully charged battery.
i Wait until charging is completed before
pressing the Shutter button.
i Pop up the flash.
i Select another Scene Position or change
the photography mode.
i Set continuous shooting to OFF.
The flash settings are restricted because
the camera settings are tailored to the
scene being shot. Change the
photography mode for a wider range of
flash settings.
Set continuous shooting to OFF.
In the Photography menu, set the
sensitivity to 400 or less.
i Move to within the effective flash range
before taking the shot.
i Hold the camera correctly.
Troubleshooting Possible causes Solutions
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fujifilm Finepix F 610 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fujifilm Finepix F 610 in the language / languages: English as an attachment in your email.

The manual is 5,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info