101064
37
Zoom out
Zoom in
Previous page
1/41
Next page
7372
I cant use the flash to take
pictures.
The flash will not charge.
The playback image is too
dark even though I used the
flash.
The image is blurred.
I cannot format the
SmartMedia.
I cannot erase all the frames.
Nothing happens when I use
the camera buttons and
switches.
No image appears when I
press the, DISP button.
The camera switches to Macro mode.
The shutter button was pressed when the
viewfinder indicator was blinking orange.
No compatible SmartMedia is loaded.
The camera is set to Suppressed Flash mode.
The batteries are exhausted.
The subject is too far away.
Your finger is covering the flash.
The lens is soiled.
Macro photography was used to photograph
scenery.
The SmartMedia is write-protected.
The frame is protected.
DPOF settings are specified for one or more of
the frames.
Camera malfunction.
The Mode dial has been moved to another
setting.
The batteries are exhausted.
The Mode dial is set incorrectly.
Cancel Macro mode (allows forced flash and
slow-synchro photography).
Wait until the flash has finished charging before
pressing the shutter button.
Load a new SmartMedia, erase a frame, or
remove the write-protection.
Set the flash mode to Auto, Red-Eye Reduction,
Forced Flash or Slow Synchro.
Load new batteries.
Move closer to the subject.
Hold the camera correctly.
Clean the lens.
Cancel Macro photography.
Remove the write-protection.
(Peel off the write-protect sticker.)
Remove the frame protection.
Reset the DPOF settings.
Remove the batteries, re-insert them and try again.
Move the Mode dial to the correct setting.
Load new batteries.
Move the Mode dial to the correct setting.
Problem Cause Remedy
Troubleshooting
eBefore you decide the camera is faulty, check the following once more.
No power
Power cuts out during
operation.
Battery runs out quickly.
No photograph is taken
when the shutter button is
pressed.
I cant use the flash to take
pictures.
Load new batteries.
Plug the adapter back in.
Load new batteries.
Put the batteries in your pocket or another
warm place to heat it and then load it into the
camera just before you take a picture.
Wipe the battery terminals with a clean, dry
cloth.
Load new batteries.
Load a SmartMedia.
Erase some images or use a SmartMedia that
has ample free space.
Remove the write-protection.
Format the SmartMedia.
Wipe the SmartMedia contact area with a
clean dry cloth.
Load a new SmartMedia.
Switch the camera on.
Load new batteries.
Set the flash mode to Auto, Red-Eye Reduction,
Forced Flash or Slow Synchro.
Set continuous shooting to OFF.
Problem Cause Remedy
The batteries are exhausted.
The AC power adapter plug has come out of
the power outlet.
The batteries are exhausted.
You are using the camera in extremely cold
conditions.
The terminals are soiled.
The batteries are flat.
No SmartMedia is loaded.
The SmartMedia is fully recorded.
The SmartMedia is write-protected.
The SmartMedia is not formatted.
The SmartMedia contact area is soiled.
The SmartMedia is damaged.
The Auto Power Off function has switched
the camera off.
The batteries are exhausted.
The flash is set to Suppressed Flash mode.
The camera is in continuous shooting mode.
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fujifilm Finepix 2300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fujifilm Finepix 2300 in the language / languages: English as an attachment in your email.

The manual is 1,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info