803542
70
Zoom out
Zoom in
Previous page
1/74
Next page
64
SERVICE
Mögliche Fehler Abhilfe
Das System lässt sich nicht über das
Bedienteil einschalten
Der Akku ist nicht geladen
Der Akku ist defekt
Die Sicherung im Akku ist defekt
Der Akku wurde nicht eingeschalten
Die Akku-Kontakte sind verschmutzt
Die Steckverbindung zum Display hat sich gelöst – Kontakt wieder herstellen
Das Bedienteil/ Display ist defekt
Das Display ist an, es erfolgt dennoch
keine Unterstützung
Der Unterstützungsmodus steht auf „0“
Die Geschwindigkeit ist höher als 25 km/h
Der Akku ist fast leer und es blinkt der letzte Balken im Display
Die Akku-Kontakte sind verschmutzt
Es erscheint „error 23“ oder „error 24“; die Steckverbindung zum Motor hat sich gelöst
– Kontakt wieder herstellen
Der Motor funktioniert trotz richtiger Bedie-
nung nicht
Ein Bremskontakt weist einen Fehler auf – Kabelkontakte sind zu prüfen bzw. die
Hebeleinheit austauschen; ggf. wird im Display „error 25“ angezeigt
Der Abstand der Magnetscheibe zum Sensor am Riemenrad ist >3mm; dieser Ab-
stand ist zu korrigieren
Der Motor gibt nicht dieselbe Leistung ab
wie unmittelbar nach Produktkauf
Das System aus und wieder einschalten; falls keine Besserung eintritt, hat der Akku
bereits sein Leistungspotential durch natürliche Alterung eingebüßt
Der Motor schaltet bei Bergfahrt ab Die max. Motortemperatur wurde überschritten und die Motorleistung wird aus Sicher-
heitsgründen zurückgenommen
Die Belastung des Motors wird zu groß – der Motor schaltet zum Eigenschutz ab
Motor funktioniert nicht bei niedrigen Tem-
peraturen.
Unter einer Temperatur von -10°C gibt es keinen Strom vom Akku, da dieser dadurch
beschädigt werden könnte. Akku langsam erwärmen
Fehlercheckliste
Flluid 1
SERVICE
Possible Errors Remedy
The system can not be switched on via the
control panel
The battery is not charged
The battery is defective
The fuse in the battery is blown
The battery is not turned on
The battery contacts are dirty
The plug connection to the display has come off - restore contact
The control panel / display is defective
The display is on, but there is still no assist The assist mode is set to "0".
The speed is higher than 20/28 mph Flluid1/1S
The battery is almost empty and the last bar in the display ashes
The battery contacts are dirty
"error 23" or "error 24" is displayed; the plug connection to the engine has come off –
restore contact
The motor does not work despite correct
operation
A brake contact has an error - Check cable contacts or replace the lever unit; if neces-
sary, the display shows "error 25"
The distance of the magnetic disc to the sensor on the belt wheel is> 3mm; this dis-
tance must be corrected
The engine does not deliver the same
performance as immediately after product
purchase
Turn the system off and on again; adjust the power settings, if there is still no improve-
ment, the battery may require maintenance – please call FUELL.
The engine shuts off when driving uphill The max. motor temperature has been exceeded and the motor power is withdrawn
for safety reasons. The load of the engine is too large - the engine switches off for
self-protection
Engine does not work at low temperatures. Under a temperature of -10 ° C, there is no power from the battery, as this could dam-
age it. Warm the battery slowly
Error Checklist
70


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fuell Flluid 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fuell Flluid 1 in the language / languages: English as an attachment in your email.

The manual is 8.21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fuell Flluid 1

Fuell Flluid 1 User Manual - German - 74 pages

Fuell Flluid 1 User Manual - Dutch - 74 pages

Fuell Flluid 1 User Manual - French - 74 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info