453972

Frigidaire GLVC25V7DB1 Manual

5
Zoom out
Zoom in
Previous page
1/138
Next page
Connecting The Water Supply
About Your Refrigerator’s Water Supply
The automatic ice & water dispenser on your refrigerator requires a
permanent water supply to function correctly. During installation,
you (or a service professional) establish this water supply by
connecting a copper tube from your household water system to a
valve at the rear of the refrigerator.
Caution
To Avoid Property Damage:
• Use copper tubing for the water supply line (plastic tubing is
more likely to leak). Manufacturer is not responsible
for any damage if plastic tubing is used for supply line.
• Ensure water supply complies with local plumbing codes.
• For proper dispenser operation, recommended water supply
pressure should fall between 1.4 and 6.9 bars. Excessive
pressure may cause water filter to malfunction.
What you will need:
• Access to a cold water line with pressure of 1.4-6.9 bars.
• The water connector kit that comes with your refrigerator, which
provides all materials for a water installation, including 7.6 m (25
feet) of copper tubing.
To connect your water supply to the rear of your
refrigerator:
1 Ensure that the refrigerator is not plugged in.
2 Flush the supply line until water is clear by placing the end of the
copper tube in a sink or bucket and opening the shut-off valve.
3 Unscrew the plastic cap from water valve inlet at the rear of your
refrigerator. Discard the cap.
4
Slide the brass compression nut, then the ferrule (sleeve) onto
copper tube.
5 Push the copper tube into water valve inlet as far as it will go (6.5
mm).
6 Slide the ferrule (sleeve) into valve and finger-tighten
compression nut onto valve. Tighten another half turn with a
wrench. Do not over-tighten.
7 Secure the copper tube to your refrigerator’s rear panel with a
steel clamp and screw (see illustration).
8 Coil the excess copper tubing (about 2½ turns) behind your
refrigerator as shown. Arrange coiled tubing to avoid vibration or
wear against other surfaces.
9 Open water supply shut-off valve and tighten any connections
that leak.
Note
After connecting the water supply, see information in this guide
about priming an empty water supply system. Also read all
topics in the “Automatic Ice & Water Dispenser” section to learn
about normal operating procedures.
Controls & Settings
Allowing Cooling Time Before Use
To ensure reliable food storage, allow your refrigerator and freezer
to operate with the doors closed for 8 to 12 hours before placing
food inside. During this cooling period, you do not need to adjust the
controls, which are preset at the factory.
Setting Cooling Temperatures
Your refrigerator comes with a state-of-the-art electronic digital
control system. The system’s control panel is located at the top of
the refrigerator compartment.
The two digital displays on the left half of the control panel indicate
the current temperatures of your freezer and refrigerator
compartments.
To adjust the temperature to a higher or lower setting, press the Up
or Down arrow button closest to the display. The first time you press
the button the display shows the last setting you entered. Each
press of the button after that increments the setting by one degree.
The display shows your new setting momentarily, then changes
back to the current temperature.
Note
The advanced electronic control system in your refrigerator
includes additional display modes that service professionals can
use to rapidly diagnose performance issues.
5
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Frigidaire GLVC25V7DB1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Frigidaire GLVC25V7DB1 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 11,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info