3
To remove the chime battery cover, press at
point (C) and slide the cover back 5mm, then
lift off. Insert 4 x LR14 ‘C’ alkaline batteries,
(not supplied). Observe polarity as marked
inside the battery compartment (Fig. 3).
Fit the chime batteries
Using a ball point pen, press at point shown in
Fig 1 (A) and remove the name plate. If desired, you
can prise apart the two halves of the name plate
and write on the card. Undo the retaining screw
(B) and remove the back of the push.
Open the bell push/converter
remove nameplate
Insert the CR2032 coin cell. Ensure the face
marked ‘+’ is uppermost (Fig. 2).
To fit the push/converter battery
Fig. 2
CR2032
+
Fig. 3
C