787179
17
Zoom out
Zoom in
Previous page
1/18
Next page
PFS
27
EN
Troubleshooting
ActionSymptom Cause
The fan symbol is
flashing. No heat
and the fan runs at
maximum speed.
The text "Heat OFF"
appears. No heat.
The text "Sens Out"
flashes in the display
and there is no heat.
The text "Sens In"
flashes in the display
and there is no heat.
The fan convector emits
heat, but it becomes
progressively more
difficult to achieve
the desired room
temperature, even
though the settings are
unchanged.
All the fans are inactive.
The internal temperature has exceeded
the upper limit, even though the heat
is off. The fans automatically run at the
highest speed and the heat is blocked
until the internal temperature is below
the limit, and then return to the previous
settings.
The control considers that no heat is
emitted from the heating element. (The
temperature difference between the
room sensors and internal sensors is
less than 5 °C after 90 sec.)
The upper sensor is defective or is de-
tached from its fastening.
The lower sensor is defective or is de-
tached from its fastening.
The internal temperature reaches its limit
value faster, which limits the heat emis-
sion.
Check that the air flow is not
blocked at the intake grille or
outlet grille.
Clean the inside of the unit.
Check that the internal sensor
(at the outlet grille) are placed
correctly.
Check that the air flow is not
blocked at the intake grille or
outlet grille.
Disconnect the power for at least
10 minutes in order to reset the
overheat protection.
Reconnect power and cancel the
alarm by pressing the OK button
for 3 seconds.
Contact Frico for support.
Contact Frico for support.
Check that the air flow is not
blocked at the intake grille or
outlet grille.
Clean the inside of the unit.
Check that all motors operate
correctly.
The fan speed is set to OFF.
The function with fans off at reduced
mode (FRT) is active.
The quick plug for the first motor is de-
tached.
Switch fan mode to Auto.
Put FRT function to OFF in Settings.
Check the fan motor connections.
If the problems continue, please contact Frico for support.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Frico PF Smart at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Frico PF Smart in the language / languages: English as an attachment in your email.

The manual is 0.49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info