787198
6
Zoom out
Zoom in
Previous page
1/8
Next page
INSTALLATION DETAILS:
The ideal mounting position is directly above the area to
be heated with a longitudinal orientation and facing
vertically downwards.
WARNING:
The heater must never be installed in the upwards or
inwards facing position, the heating surface must always be
positioned to direct the heat in a downwards or outwards
direction.
Find below the minimum clearances when mounting the
heater parallel with a ceiling. (Unit in mm)
Find below the minimum clearances when mounting the
heater at an angle to the ceiling. (Unit in mm)
Find below the right wall mounting position. (Unit in mm)
WARNING:
Mounting of the infrared heater and its connection to
the electric mains should be carried out only by
qualified specialists according to the Electrical
Installation Regulations and Power System Safety
Standards.
INSTALLATION PROCESS:
1. Open the factory package and carefully take the heater
out.
2. Take out the packing paper sheet from the end of heater.
3. Take out one pair of mounting Brackets. These adjustable
brackets allow direct ceiling or wall mount, and come with
preset angle options of parallel, 15°, 30°, 45° and height
165mm.
4. The correct installation process, as per the diagram
above, select the heater location on the ceiling by locating
the stud or structural beams to ensure secure fastening of
the heater, whilst observing the minimum clearances from
the floor and other objections.
5. Install two brackets on the ceiling or wall with the
following minimum recommended bracket distance “B”.
6. Set the adjustable angle mounting brackets to desired
angle and fasten brackets by spanner.
EN
13
165m m
15
mm
Inclined ceiling mount
Horizontal ceiling mount
Angled horizontal ceiling mount
Fans, lights and
sprinkler fittings
MUST NOT
be below heater
Same on both
ends
1000 mm minimum to surface
(ie table tops, etc)
2100 min. from floor
3000 mm max. from floor
(recommended)
Correct Installation
WALL
WALL
WALL
CEILING CEILING CEILING
Incorrect Installation
Fans, lights and
sprinkler fittings
MUST NOT
be below heater
Same on both
ends
1000 mm minimum to surface
(ie table tops, etc)
2100 min. from floor
3000 mm max. from floor
(recommended)
Fans, lights and
sprinkler fittings
MUST NOT
be below heater
1000 mm minimum to surface
(ie table tops, etc)
2100 min. from floor
3000 mm max. from floor
(recommended)
Same on both
ends
Correct Installation
WALL
CEILING
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Frico IHGB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Frico IHGB in the language / languages: English as an attachment in your email.

The manual is 0.97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Frico IHGB

Frico IHGB User Manual - German - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info