664131

Freerider FR510DXXs Manual

31
Zoom out
Zoom in
Previous page
1/48
Next page
31
FIG 39
FIG 40
BASIC FAULT FINDING
If your Freerider Scooter will not start:
If the battery condition meter fail to operate when the
key switch is in the 'on' position, check the following:
Freerider
The battery condition indicator meter , your Freerider
does not drive:
1. Check the power key switch is turned fully 'on'. If it is,
the battery condition indicator meter displayed on your
console, will be operating. If the first red status light is
flashing once per second, charge your batteries.
1. Make sure the battery charger is not plugged into the
tiller charge socket, this will prevent drive.
2. Check both battery connectors ( grey connectors ).
Check battery terminal condition ( fig 23, page 21).
3. Check the 'circuit breaker': If your Scooter stops
for no apparent reason, it is probably due to the circuit
breaker disconnecting from the speed control electronic
box (see fig 40). On rare occasions, a temporary
overload on the electric circuit can occur - for instance
when climbing a steep incline. If this happens, the circuit
breaker situated under the rear body cover will trip and
all power to your drive system will be automatically
switched off. Wait for approximately 60 seconds, switch
the circuit breaker to 'on 'by entering a finger through
the access hole in the top of the rear body cover (located
under your seat ) and press the switch down. The battery
gauge will light up and you are now ready to drive again.
If the circuit breaker trips up again wait for 5 minutes and
try again.
If you find the circuit breaker is continually tripping
out, contact your authorised dealer.
1. Check the 'white' plug's, located under the rear
cover and positioned in the main controller module
(see Fig 41).Also check status fault codes (page 32 )
Caution:
If your Freerider Scooter will not start:
If
the battery condition
meter fail to operate when the
key
switch
is in
the
'on' position,
check
the following:
Freerider
The
battery
condition
indicator
meter
,
your
F
reerider
does
not
drive:
Caution:
HANDLE BAR BEARINGS
The bearings which control the movement of the steering
handle bar may need to be adjusted if up and down
movement is noticed in your steering handle bars.
The bearings are accessed by lifting the back rubber cover at
the base of your handle bars and the front body cover.
The bearings are adjusted by first releasing the locking nut
anti-clockwise one full turn with a suitable spanner (fig 39).
Turn the upper bearing adjustment nut clockwise, one flat at
a time until all of the up and down movement in the handle
bars is removed. Retighten the lock nut clockwise into
position with a second spanner. Do not overtighten the
bearing adjustment nut, as this will damage the bearing
tracks.
HANDLE BAR BEARINGS The handle bar bearings are NOT 'Sealed for life' and may
require lubrication with a general purpose bearing grease
on an annual basis.
NOT 'Sealed for life' and may
require
lubrication with a general purpose bearing grease
on
an annual basis.
FIG 42
motor
&
brake
charge
output
tiller
console
supply
Battery input
+
FIG 40
FIG 41
FIG 41
FIG 40
FIG 42
Controller
P&G EGIS 110
… 31 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Freerider FR510DXXs at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Freerider FR510DXXs in the language / languages: English as an attachment in your email.

The manual is 2,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info