665066
32
Zoom out
Zoom in
Previous page
1/40
Next page
SPEED CONTROLLER SETTINGS
The forward-reverse speed Controller (Fig 42 page 31) is a
state-of-the-art microprocessor designed to give smooth and
safe operation. For maximum performance, protection and
convenience the Controller is housed in a solid die cast
aluminium case situated under the rear body cover.
The speed Controller, ‘Dynamic’ model DS72KO1(Rhino
70amp) is programmed by Freerider to obtain the maximum
performance and safety for your Companion Scooter.
Warning: Performance adjustments should not be made
which could put the operator in a serious situation of
control or braking. Performance adjustments should only be
made by a person fully trained and conversant with the
programming process and it’s capabilities.
Warning: Incorrect settings could cause injury to the
Scooter operator and/or to bystanders, or damage to the
vehicle and/or surrounding property. If in doubt consult
your Freerider Manufacturer
The original manufacturer’s settings for this Scooter are:
32
SETTINGS
2
8
9
4
4
N/A
60
15
70
6
SETTINGS
OFF
OFF
OFF
OFF
ON
ON
ON
OFF
ON
SET-UP MENU DESCRIPTION
Acceleration
Deceleration
Forward Speed
Reverse Speed
Reduce Speed
Buzzer Volume
Motor Resistance
Sleep Time
Maximum Current
Park Brake Delay
OPTION MENU DESCRIPTION
Single-Ended Pot
Standard Speed Pot
Motor Reverse
Pot Reverse
Brake Checking
Load Compensation
Enable Sleep
Check for Slope
Current Limit Timer
FLASH CODE
(No. of flashes)
1 Flash
2 Flashes
3 Flashes
4 Flashes
5 Flashes
6 Flashes
7 Flashes
8 Flashes
9 Flashes
FAULT DISPLAYED
BY PROGRAMMER
Battery needs recharging
Battery voltage too low
Battery voltage too high
Current limit time out
Brake fault
Out of neutral when power
switched on at key switch
Speed pot error
(wig wag)
Motor volts error
Other internal errors
FREERIDER SCOOTER
CONDITION
Driving still possible
Drive inhibited
Drive inhibited
Drive inhibited
Drive inhibited
Drive inhibited. Drive possible if neutral
selected within 10 secs.
Drive inhibited
Drive inhibited
Drive inhibited
COMMENT
The battery voltage has dropped below 23.3 volts in neutral.
Recharge the batteries soon.
The battery voltage at Controller has dropped to 16.5 volts.
Check the battery condition and the connections.
The battery voltage at the controller is greater the 32 volts.
Check the battery condition and the connections. Suspect a
charger malfunction.
The Controller has detected a shorted or overworked motor.
Check the loom for shorts or check out the motor. Contact
your Service Agent.
Check the Freewheel Lever is fully engaged. Check the Park Brake
and wiring for open or short circuits. Contact your Service Agent.
Return the speed lever to neutral. Re-adjust the speed lever
neutral if necessary. Consult your Service Agent.
Check speed pot wiring for open or short circuits. Speed pot
may not be correctly set up. Contact your Service Agent.
Motor or wiring is faulty. Contact your Service Agent.
Contact your Service Agent.
STATUS FAULT CODES
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Freerider Companion FR168-3A2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Freerider Companion FR168-3A2 in the language / languages: English as an attachment in your email.

The manual is 1,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info