665066

Freerider Companion FR168-3A2 Manual

29
Zoom out
Zoom in
Previous page
1/40
Next page
29
RECOMMENDED SERVICE INTERVALS
DAILY Check the following:
•
Operation of motor brakes (see page 11 & 27)
•
Operation of driving brake (see page 9 & 27)
•
Operation of seat lock (see page 6)
•
Tyre condition (see page 27 & 28)
•
Front basket and any carrying accessory is firmly attached
(see page 18, Fig 25)
•
Batteries are fully charged (see pages 21-26)
Caution: Only drive your Companion Scooter if it is in full
working order.
WEEKLY Check the following and adjust as necessary:
•
Check chassis locking mechanism (see 8 page 18)
•
Arm rest tightening knobs (see page 6)
•
Tyre pressures (see Technical Specification, page 33)
•
Battery fastening (see page 17)
•
Allow battery charger to go through a full recharge cycle
until the green light is illuminated (see pages 21-26)
•
Clean paintwork with auto shampoo. Do not use a high
pressure hose. Wax painted and bright metal parts.
SIX MONTHS Check and adjust as necessary:
•
Tyre wear, replace as necessary
•
All fasteners and fittings for sound function
•
Tension of handle bar lock and hinge bolt
•
Battery connections
•
Inspect all electrical plugs and sockets for damage and good
contact and fit.
Lubricate the following:
•
Wig-wag accelerator lever pivot point (see Fig 38)
•
Spray metal parts with moisture repellent (WD40)
•
Seat lock lever pivot bolt
•
Seat rotation, grease face of seat post and pivot pin at base
of seat.
•
Seat arm hinges
•
Inspect, lubricate and adjust upper handle bar steering
bearings
ANNUALLY Check the following and adjust as necessary:
•
Motor carbon brush wear (minimum brush length 8mm)
•
Front wheel bearings for wear
•
Handle bar bearings
•
Chassis for sound welds
•
Rear Drive wheel hub keys
•
All wheel bolts
•
Drive axle securing bolts
•
Motor mounting bolts
•
Magnetic motor brake disc and function
•
Main control box electrical connections
•
Main wiring loom for damage
•
All steering components
•
Clean chassis and repaint any exposed parts
•
Lubricate on/off power key barrel
•
Replace any damaged axle seals
•
Cycle test charger for full operation function
•
Cycle test batteries for operating capacity (This test can be
performed by your Freerider Agent)
Note the items listed under weekly and six months should
be incorporated into this annual inspection.
LUBRICATION
Use a general purpose light lubricating oil on moving parts. All
wheel bearings are factory sealed and should not normally
need lubricating. Handle bar bearings should be lubricated
with a general purpose bearing grease.
Your drive axle is factory filled with a special lubricant and will
not normally need replacing.
Caution: Do not mix other lubricants with this factory fitted
drive axle lubricant. Failure to observe this caution will
invalidate your guarantee.
Please note: These service intervals are a guide, more
frequent use of your Scooter may require adjustment to
these suggested intervals.
FIG 38
FIG 39
… 29 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Freerider Companion FR168-3A2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Freerider Companion FR168-3A2 in the language / languages: English as an attachment in your email.

The manual is 1,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info