610566
10
Zoom out
Zoom in
Previous page
1/24
Next page
www.foodsaver.com 1-877-777-8042
10
Using FoodSaver
®
Vacuum Sealing Accessories
Avoid wrinkles when inserting the bag into the
Vacuum Channel (G).
Wrinkles in seal may cause leakage and allow
air to return into bag. To eliminate any wrinkles
while inserting bag, gently slide bag curl down
into the Vacuum Channel (G), and hold bag with
two hands gently stretching bag flat until vacuum
pump begins. If you find wrinkles after sealing
bag, simply cut bag open and vacuum seal again.
If motor runs for more than 30 seconds without
stopping, consider the following:
If you are vacuum sealing with a bag, make sure
one end of the bag is properly sealed. (See “How
to Make a Bag From a Roll” on page 8.)
If vacuum sealing with an accessory, check
Handheld Sealer connections to ensure a tight fit.
Removing Air from a Bag
FreshSaver
®
Zipper Bags
1. Place food into Zipper Bag. Make sure not to put
any food under valve. Press zipper closed with
finger while bag is lying down on a flat surface.
2. Pull Retractable Handheld Sealer from appliance.
Place end over the gray valve on bag.
3. Push accessory button to begin vacuum
process. Motor will run until vacuum process
is complete.
Containers
1. Prepare container according to FoodSaver
®
Accessory Guidelines, which are included
with accessory purchases.
2. Pull Retractable Handheld Sealer from
appliance. Place end over gray valve on
container.
3. Push accessory button to begin vacuum
process. Motor will run until vacuum process
is complete.
Canisters
1. Prepare canister according to FoodSaver
®
Accessory Guidelines, which are included with
accessory purchases.
2. Pull Retractable Handheld Sealer from
appliance and remove clear bottom portion of
handheld from top handle. Insert the end into
the port on accessory. Twist tab while inserting
to ensure a tight fit.
3. Push Accessory Button to begin vacuum
process. Motor will run until vacuum process
is complete. (To Marinate, follow instructions
found in Marinating with your FoodSaver
®
Appliance section of this Guide on page 12.)
4. When motor turns off, gently twist and remove
Handheld Sealer from accessory.
NOTE: if you are using a canister with large
white knob, rotate knob clockwise to the
“Closed” position, then gently twist and
remove Handheld Sealer from accessory.
5. To test vacuum, simply tug on accessory lid. It
should not move.
6. To retract Handheld Sealer, while holding unit,
gently pull on hose end to allow hose to retract
into appliance. Do not release freely as it may
damage the Handheld Sealer.
IMPORTANT: When pulling hose Do Not extend
beyond red line marked on hose.
Fig. 1
HOW TO
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for FoodSaver V4800 series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of FoodSaver V4800 series in the language / languages: English as an attachment in your email.

The manual is 0,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info