610562
8
Zoom out
Zoom in
Previous page
1/10
Next page
www.foodsaver.com 1-877-777-8042
www.foodsaver.com 1-877-777-8042
Care and Cleaning
To Clean Appliance:
1. Press On/Off and unplug before cleaning.
2. Do not immerse in liquid.
3. Open appliance door (D), while holding the appliance
with two hands, press two Release Buttons (J) with
your thumbs, rotate appliance away from you, and
allow appliance to rest on the counter.
4. Check Lower Gasket (L) around Drip Tray (N) and
Upper Gasket (P) which surrounds the Upper Bag
Detection Tray (O) to make sure they are free from
food materials and the lower Foam Gasket is properly
inserted into gasket channel.
5. Avoid using abrasive products or materials to clean
any appliance components. These cleaners can
scratch the surface and damage the black foam
rubber pads.
6. Use a mild dishwashing soap and a warm, damp
cloth to wipe away food residue inside or around
components.
7. Dry thoroughly before reusing.
8. If your appliance features a Drip Tray, empty Drip Tray
after each use (See Fig. 7). Wash in warm soapy water
or place in top rack of dishwasher.
Antibacterial Drip Tray & Upper Bag Detection Tray
Empty Drip Tray after each use (See Fig. 7). Wash in warm
soapy water or place in top rack of dishwasher. The Food
Sensors in the Drip Tray (O) will not function correctly if
liquid is allowed to remain in Drip Tray.
This appliance has a Tray Full indicator
2
. When excess
liquid fills the Drip Tray, the unit will turn off and the
Tray Full Indicator light will activate. To resume normal
operation, open Appliance Door (D), press two release
buttons (K), rotate appliance away from you, and allow
appliance to rest on the counter. Remove the Drip Tray,
emptyliquid, clean Drip Tray and replace in housing.
When replacing drip tray, set the right end of the drip
tray into place, then firmly snap the left side down (See
Fig. 8). Appliance can be used without Drip Tray, however
the Adjustable Food Sensor setting
6
will not function
without the Drip Tray.
Clean Upper Bag Detection Tray after each use. The
Upper Bag Detection Tray (P) is removable for cleaning,
remove by lifting the tabs on each end. Do not pull on
the Upper Bag Detection Flags to remove the Upper
Bag Detection Tray. Clean Upper Bag Detection Tray by
washing in warm soapy water or placing in top rack of
dishwasher. Upper Bag Detection Tray MUST be inserted
to use the appliance. Without the Upper Bag Detection
Tray, your FoodSaver
®
Appliance will not detect bag
when inserted in the Vacuum Channel (E). After cleaning,
hold appliance with two hands and rotate upright until
the latches lock.
FoodSaver
®
Accessories
1. Wash all FoodSaver
®
accessories in warm water,
using a mild dishwashing soap. Do not immerse lids
in water.
2. Dry thoroughly before reusing.
3. FoodSaver
®
Canister bases (but not lids) are top rack
dishwasher safe. Canister lids should be wiped down
with a damp cloth.
4. FoodSaver
®
Canisters and FoodSaver
®
Lunch &
Leftover and Sandwich & Snack Containers should
not be used in the freezer.
5. FoodSaver
®
Canisters should not be used in the
microwave or freezer.
6. FoodSaver
®
Lunch & Leftover and Sandwich & Snack
Containers are microwave and dishwasher safe (top
rack only).
13 14
Troubleshooting
Nothing happens when I try to vacuum package:
1. Check power cord to see if it is firmly plugged into
electrical outlet.
2. Examine power cord for damage.
3. Check electrical outlet by plugging in another
appliance.
4. If your appliance has latches, make sure the lid is
closed and the latch is in the locked position. Refer to
your QuickStart Guide for instructions.
5. If your appliance has a mode switch, make sure it
is set to the correct mode. Refer to your QuickStart
Guide for instructions.
6. Make sure bag is placed correctly down inside the
Vacuum Channel.
7. Wait 20 minutes to allow appliance to cool off, and
then try using it again.
Note: The appliance will shut off automatically if it
becomes too hot.
To keep your appliance from overheating:
Wait at least 20 seconds for appliance to cool down
before you begin vacuum packaging another item.
Keep lid open before vacuum packaging.
Air is still in the bag:
1. Make sure open end of bag is resting entirely inside
Vacuum Channel. If edge of bag is beyond Vacuum
Channel, bag will not seal properly.
2. Examine bag for leaks. To see if your bag has a leak,
seal bag with air, submerge it into water and apply
pressure. Bubbles indicate a leak. Use a new bag if
bubbles appear.
3. If you are using a custom-sized FoodSaver
®
Bag,
check seal of bag. A wrinkle in the bag along the seal
may cause leakage and allow air to re-enter. Just cut
bag and reseal.
4. Do not attempt to make your own side seams for a
FoodSaver
®
Bag. The bags are manufactured with
special side seams, which are sealed all the way to
the outer edge. Making your own side seams may
cause leakage and allow air to re-enter.
5. Make sure Accessory Hose is not inserted into the
Accessory Port.
6. Check gasket around Drip Tray and upper gasket
under the lid to make sure it is free from food
materials and is properly inserted into gasket
channel.
Fig. 7
Remove For Cleaning
Firmly Snap in Place
Fig. 8
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for FoodSaver V3800 series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of FoodSaver V3800 series in the language / languages: English as an attachment in your email.

The manual is 0,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of FoodSaver V3800 series

FoodSaver V3800 series User Manual - English - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info