810226
15
Zoom out
Zoom in
Previous page
1/28
Next page
15
Position Logs S4, S3, & G6 as shown in the diagram.
Position Logs S2, & S5 as shown in the diagram. Scatter the Glow Strands
among the Logs and Embers. Finaly Check the appliance for Pilot ignition and
cross lighting ensuring that no material is impinginging the opertion of the Pilot.
COMMISSIONING THE APPLIANCE
A. PILOT IGNITION CHECK
1. Ignite the pilot light as described in the User Instructions
2. Check that the pilot flame stays alight
3. Extinguish the pilot light
B. MAIN BURNER CHECK
1. Ignite the pilot light as described in the User Instructions
2. Turn on the main burner as described in the User Instructions
3. Check that the pilot smoothly cross-lights to the main burner and that
the main burner and pilot stay alight
4. Check the operation of the «effect» burners as described in
the User Instructions
5. Extinguish the appliance fully
C. PRESSURE CHECK
The appliance is preset to give the correct heat inputs as listed in the
technical details. No further adjustment is necessary. Always check the
inlet pressure and burner pressure.
1. Turn off the gas valve on the appliance
2. Release the screw on the Inlet Pressure test point on the gas valve
and connect a manometer
3. Check that the measured pressure is as the prescribed supply pressure
4. Perform the test when the appliance is burning on full (inc. «effect»
burners) and with only the pilot alight
5. If the pressure is low, check the gas supply pipes are too a correct sizing
6. If the pressure is too high (more than 5 mbar over) the appliance may be
installed, but the gas supply company should be contacted
7. Release the screw on the Burner Pressure test point on the gas valve
and connect a manometer
8. Check that the measured pressure is as detailed in the Technical details
9. The measured value should be within +/- 10% of the described value.
If this is not the case, please contact the supplier.
NOTE: After checking the pressures and removing the manometers,
the screws in the Pressure Test points must be closed, and
the system must be checked for gas-tightness.
Installation instructions
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Focus SlimFocus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Focus SlimFocus in the language / languages: English as an attachment in your email.

The manual is 4.52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info