780051
16
Zoom out
Zoom in
Previous page
1/50
Next page
EN-16 Original User Guide | Pedelec Groove Next
1. Undo the seatpost bolt by turning it
anticlockwise with a 4 mm Allen key.
2. Move the seatpost into the right position.
PLEASE NOTE
When lifting the seatpost completely out of the seat tube, be careful
not to damage the light cable. The light cable for the rear light passes
through the seat post into the seat tube.
3. Tighten the seat post bolt again
byturningitclockwisewithatorque
of12-15Nmusingatorquewrench.
4. Test the tightness of the saddle by
trying to move it.
For 1.Loosenseatclamp(s)
For 3.Tightenseatclamp(s)
For 1.Loosenseatclamp(s)
For 3.Tightenseatclamp(s)
3.2 Adjusting the saddle height
Determining the correct saddle height
1. Sit on the Pedelec and at the same time lean against a
wall.
2. Turn the foot pedal on the opposite side to the wall to
its lowest point.
3. Place your heel on the pedal.
Your leg should be fully
extended.
4. If your leg is not fully
extended when your heel is on
the pedal, raise the saddle.
Lower the saddle if you cannot
reach the pedal.
WARNING
Seatpost marking
The seatpost is marked to indicate how far you
may pull it out from the frame. Never pull the
seatpost further out than the marking. This could
cause it to bend or break, and cause you to fall.
For 3. Extend leg
Original User Guide | Pedelec Groove Next EN-17
DANGER
Observe the prescribed tightening torque. Failuretocomplycan
result in screws/bolts becoming loose, tearing away or fracturing. If
that happens while you are riding the bike, components may come
oandyoucouldhaveaseverecrash.Ifscrewsareovertightened,
components can also be damaged.
If no value is shown on the component, use the torque settings from
Chapter 10. Torque settings Page EN-49
3.3 Moving the saddle
DANGER
Screw the clamping screws fully in a straight position in the nuts.
Failuretodosocanresultinthescrewstearingoutofthenuts.
correct
Front seat clamping bolts
wrong
Fig. 1 Fig. 2
1. To move the saddle, loosen the front and rear saddle clamping bolts
(M6)byturningthemanticlockwisewitha5mmAllenkey.Turn
the saddle clamping bolts completely two to three times at most,
otherwise the whole mechanism could fall apart.
2. Movethesaddlebackwardsorforwardsasrequired.
DANGER
Never clamp the saddle in the curve of the saddle rail; always do it in
the straight section. Only shift the saddle within the straight section
(Fig. 1).Saddlesthatstayclampedoutsidethisareacanfail(Fig.2).
correct
Rear seat
clamping bolts
Fig. 1
wrong
Fig. 2
3. Tighten the two saddle clamping
bolts by turning them clockwise
withatorqueof12Nmusinga
torquewrench.
For 3. Tightening the bolts
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Focus Groove Next - 2018 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Focus Groove Next - 2018 in the language / languages: English as an attachment in your email.

The manual is 14.37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Focus Groove Next - 2018

Focus Groove Next - 2018 User Manual - German - 50 pages

Focus Groove Next - 2018 User Manual - Dutch - 60 pages

Focus Groove Next - 2018 User Manual - French - 52 pages

Focus Groove Next - 2018 User Manual - Spanish - 57 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info