W
V
Maintenance
T
S
• WARNING
Disconnect from the mains electricity supply,
before attempting any maintenance or adjust-
ment. Cutting head continues to rotate after the
trimmer has been switched off. Keep fingers and
hands clear of the line cutter on leading edge of
guard.
Caring for your Contour Power Plus
After you have finished using your Flymo Contour Power
Plus follow the procedure below:
AVOID ACCIDENTAL STARTING. REMOVE PLUG
FROM MAINS AND KEEP FEET AWAY FROM THE
SWITCH LEVER WHEN: CLEANING AROUND THE
INSIDE OF THE SAFETY GUARD, REMOVING OR
REFITTING SPOOL CAP, MANUALLY FEEDING OR
REPLACING NYLON LINE.
1. Disconnect from the mains electricity supply.
2. Never clean your trimmer with water, cleaning fluids,
or solvents, just remove debris with a suitable tool, a
soft brush or dry cloth.
3. Using a soft brush, clean around the inside of the
safety guard, the cutting head (Fig S) and the motor
housing air vents. (Fig T)
4. Remove the wheel by pressing one of the buttons.
Clean the wheel and groove on trimmer head with a
soft brush (V & W).
5. Attach wheel as described in Wheel Assembly.
6. Inspect the trimmer carefully, especially the parts of
the cutting head.
7. If your trimmer is damaged in any way contact your
local approved service centre.
• Never use a damaged trimmer.
8. Store in a cool, dry place and out of reach of chil-
dren.
Cable Storage
1. Your mains cable can be stored on the product as
illustrated in Fig X.
2. Wind cable carefully to avoid kinking.
3. To release the cable press the button and the hook
will drop down (Fig Y).
4. Push cable hook fully back into position.
Y
X
