732994

Flyer RS serie - Panasonic Manual

141
Zoom out
Zoom in
Previous page
1/275
Next page
139
EN
Loading the battery
The battery can be charged while it is installed in
the e-bike or once it has been removed.
1) Remove the rubber cap
Open the rubber cap on the battery.
Connect the mains plug to a mains socket (220
V - 240 V AC) and connect the charger to the
battery.
Do not connect the charger to the mains
socket immediately after a sudden tem-
perature change from cold to warm. It is
possible that condensed water has col-
lected on the contacts and this will lead
to a short circuit. Do not connect the bat-
tery to the charger immediately after a
sudden temperature change from cold to
warm. Wait until both devices have
reached room temperature before con-
necting the charger or the battery. Al-
ways charge and store the battery and
the charger in a dry and clean environ-
ment.
2) Check the LED charge status indicator
Check whether the charge status LED is lit up.
The LED lights up according to the charge status.
The charge status LED goes off when the charg-
ing process has been completed.
The charging time takes longer if the
battery temperature is too low or too
high.
A fully charged battery cannot be charged any
further.
The battery may not be recharged when
it indicates a fault. The battery might be
damaged after being dropped or due to
mechanical impact, even when there is
no visible external damage. Such batter-
ies must therefore be inspected by a
FLYER specialist retailer. Never try to
open a battery or to repair it.
Protective cap
Charger
3) Remove the plug from the power outlet
Separate the mains plug from the mains socket
after disconnecting the battery from the charger.
It is important that the rubber cap is rmly reat-
tached before using the battery.
Safety warning regarding the battery charger
The name plate refers to warning notes and other
safety information in connection with handling the
charger. It is important to read them before using
the charger.
Use only the original Panasonic
charger supplied along with your
e-bike. Only this charger is designed for
the lithium-ion battery used on your
e-bike.
Completely charge the battery using the
charger before the rst ride to ensure full
battery performance. Read and adhere
to the operating instructions for the
charger when loading the battery.
The battery can at any time be charged outside
or installed in the bicycle without reducing its life
span. Interrupting the charging process does not
damage the battery.
The battery is equipped with a temperature moni-
tor that permits charging only within a tempera-
ture range of 0 °C to 40 °C. If the battery temper-
ature is too high, the battery will not charge. In
addition, if you press the control button for the
LED battery charge level, the LED at the very top
[F] and bottom [E] will blink.
Separate the battery from the charger and wait
until it has reached operating temperature. Only
reconnect the charger when it has reached the
permitted operating temperature.
… 141 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Flyer RS serie - Panasonic at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Flyer RS serie - Panasonic in the language / languages: English, German, Dutch, French, Italian, Norwegian as an attachment in your email.

The manual is 11,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Flyer RS serie - Panasonic

Flyer RS serie - Panasonic User Manual - Dutch - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info