803523
304
Zoom out
Zoom in
Previous page
1/389
Next page
68
A brake test is required before each ride and particu-
larly after each brake adjustment.
Braking behaviour may vary, in particular after ex-
changing the brake pads.
Disc brakes require a bedding-in time to wear in
the discs and pads. The braking system only de-
livers its full performance after around 10 braking
cycles from 30 km/h. The braking force increases
during this time. Consider this during the entire
duration of the wearing-in period.
This wearing-in period is also required after re-
placing the brake pads or discs.
Pay attention to any unusual noise when braking,
as this could be a sign that the brake pads have
worn down to the wear limit. Check the thickness
of the brake pads once the brakes have cooled
down.
If necessary, have the brake pads replaced.
Please do not touch the brake disc while
itisrotating.Youcansu󰀨erseriousinju-
riesifyourngeriscaughtinthegapsof
a rotating brake disc.
The brake calliper and disc may get hot
during braking.
Youcouldsu󰀨erburnsifyoutouchthis
part during or directly after braking.
Have the brake disc replaced if it is worn out or
bent. This replacement procedure must be car-
ried out by a FLYER specialist retailer.
Airbubblesindiscbrakes
You can avoid this problem by applying
the brake lever before transport and then
xing it in this position using a strap.
This prevents any air from entering the
hydraulic system. Please note that the
brake lever may not be pulled when the
wheel has been removed. Place a spac-
er between the brake blocks if you need
to remove the wheel.
18. Lightingsystem
Your FLYER e-bike's lighting system is usually
powered by the battery. When the battery is emp-
ty, the light should still work for about one hour.
The headlight must be aligned to illuminate the
road according to the legal regulations of your
country.
Have the lighting system checked and, if
necessary, replaced by your FLYER
specialist retailer if a fault occurs.
18.1 Lights
Please refer to Chapters 5.4 or 5.7 on the function
and operation of the lights
In their default factory conguration, FLYER
UprocXe-mountainbikesareclassiedassports
equipment. They are not compliant with StVZO
(the German regulations authorising the use of
vehiclesforroadtra󰀩c)andthereforearenotau-
thorised for use on roads. If you wish to use your
FLYER e-mountainbike on public roads, you will
needtoaskyourFLYERdealertottheneces-
saryequipment(light,reectorsetc).
Passivelighting(reectors)isincludedwithyour
purchase. Reectors are no substitute for the
necessarylights,butwillsignicantlyimprovevi-
sibility at dawn and dusk.
When attaching the reectors, please be aware
of the following:
Make sure that the reflectors are fitted
correctly and that they are not cover-
ed by other components, clothes or
accessories.
Before every journey, check that the
reflectors are properly and securely
fastened, clean and free of damage.
Do not make modifications to the re-
flectors. Replace defective reflectors
or have them repaired.
If you wish to use your FLYER mountainbike on
public roads, you will need to ask your FLYER de-
alertotthenecessaryactiveequipment(head-
light and rear light). Pay attention to the general
information on lighting in the section below.
Generalinformationonlighting
Do not use the high beam when vehicles
are coming the other way. You should
alsoavoidusingyourhighbeamintra󰀩c
queues, in built-up areas or around pe-
destrians.
If your FLYER has a brake light, check it
regularly to make sure that it is working
properly and consult your FLYER spe-
cialist retailer if you are unsure or have
a problem.
The daytime running light is only to be
used for signalling to other road uses
andisswitchedonando󰀨independent-
ly by a sensor.
Cleanyourreectorsandlightsonareg-
ularbasis.Warmwaterwithcleaningu-
id or washing up liquid is suitable here.
304


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Flyer GOROC X 2022 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Flyer GOROC X 2022 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 19.6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info