624069
30
Zoom out
Zoom in
Previous page
1/36
Next page
LinkRunner AT 1000/2000 Network Auto-Tester
Users Manual
22
Using PoE Feature
PoE is disabled by default. To enable PoE, select Tools > PoE
Configuration, and check Enable PoE. Select the Class
you want to verify. If you have purchased the LR-AT 2000,
you can TruePower
TM
test the Class. The results are displayed
in the Autotest and Switch tests.
When you select a PoE Class higher than the switch can
handle, LR-AT 2000 will provide the loaded results
indicating the switch can not handle this Class setting. The
LR-AT 1000 will display the unloaded results indicating
voltage and wattage selected.
The following example was tested on a Class 3 (13w) switch.
The tester PoE configuration was set to Class 4 (25w) with
TruePower
TM
disabled.
Figure 19 displays the AutoTest results and Figure 20
displays the Switch results. Notice in the Autotest results,
the wire pair polarity, wattage requested and wattage
received, voltage and PSE type are given.
PSE is the Power Sourcing Equipment rating, Type 1
(12.95W - 15.40W) and Type 2 (25.5W - 34.20W).
ffy37.bmp
Figure 19. TruePower
TM
Disabled PoE AutoTest Results
In the next example, the Switch results are shown with the
same setup, i.e., no load, Class 4 (25.5w).
ffy39.bmp
Figure 20. TruePower
TM
Disabled PoE Switch Results
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke networks LinkRunner AT 2000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke networks LinkRunner AT 2000 in the language / languages: English as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info