624068
31
Zoom out
Zoom in
Previous page
1/36
Next page
Using AutoTest, Switch, and Cable Test
23
ffy47.bmp
Figure 21. TruePower
TM
Enabled PoE AutoTest Results
ffy38.bmp
Figure 22. TruePower
TM
Enabled Poe Switch Results
Notice the switch was loaded down to
5v indicating it does
not support the selected Class.
Using the Reflector Feature (LR-AT 2000 only)
The Reflector feature allows the LR-AT 2000 to be used as a
remote device for Fluke Networks EtherScope Network
Assistant, MetroScope Service Provider, and the OptiView
Analyzer’s throughput performance tests.
See Reflector Configuration on page 14 for setting up this
feature. Once set up, the device can be used as the remote
responding device for throughput performance testing.
There is no start or stop, and no results are displayed on the
tester.
Using the Fiber Connection
Simply plug in the desired SFP adapter into the fiber port
on the top of the tester and connect the fiber cable to the
network. If both fiber and RJ-45 copper are connected to
the network, the copper connection has priority.
Figure 23 shows the Switch results through a fiber
connection with link, 1000 Mbps speed, full duplex, with a
signal strength of 7.35dBm.
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke networks LinkRunner AT 1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke networks LinkRunner AT 1000 in the language / languages: English as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info