775824
50
Zoom out
Zoom in
Previous page
1/92
Next page
CableIQ Qualification Tester
Users Manual
40
avv48f.eps
A Length of the cabling. This example shows
approximate length (). Length may be
approximate or may not be shown ( ) if the
port does not produce a reflection. This occurs with
newer hubs and switches that use common-mode
termination.
Length may fluctuate or be obviously too high if the
port’s impedance fluctuates or varies from the
cable’s impedance. When in doubt, disconnect the
cable from the port to get an accurate length
measurement.
B The type of port detected:
10BASET, 100BASETX, 1000BASET: An Ethernet port that
communicates at 10, 100, or 1000 Mb/s (megabits per
second). Ports may support multiple speeds. FDX indicates
a full-duplex port, which can transmit and receive data at
the same time. Speed and duplex information are reported
only for autonegotiating ports.
INACTIVE PORT: The port shows no electrical activity. The
port may be unused, or the device may be turned off.
Device: The port does not appear to be a standard
Ethernet port.
NP: A “next page” flag was detected in the port’s
broadcast of capabilities. In most cases, this indicates the
port has 1000BASE-T capability; however, ports made by
some manufacturers broadcast this status flag without
supporting 1000BASE-T.
C Signal direction. This example shows a port that can
transmit or receive on either pair (Auto-MDIX).
-continued-
Figure 15. Discover Mode Results for Twisted Pair Cabling (cont.)
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke networks CableIQ at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke networks CableIQ in the language / languages: English as an attachment in your email.

The manual is 1.07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info