775824
45
Zoom out
Zoom in
Previous page
1/92
Next page
Qualifying Cabling with the Autotest
35
avv42.bmp
avv45.bmp
The cabling failed the Autotest because it
is shorted. The short is at 82.9 m in this
example.
Note
Devices with low input resistance
may be reported as a short.
There is a splitter or fault somewhere along the cabling. Faults that typically
cause this message are impedance faults, such as a section of cable with the
wrong impedance.
If there is a splitter between the tester and wiremap adapter, the tester
cannot verify continuity to the adapter, and may indicate that a device is
connected.
Length cannot be determined because the splitter or fault interferes with
reflections used for length measurements.
Tip: Use the TDR plot in Discover mode to locate impedance problems on
coaxial cabling. See page 44.
The Splitter or Fault message may also appear on the other coaxial screens
described in this section.
-continued-
Figure 14. Autotest Results for Coaxial Cabling (cont.)
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke networks CableIQ at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke networks CableIQ in the language / languages: English as an attachment in your email.

The manual is 1.07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info