775824
35
Zoom out
Zoom in
Previous page
1/92
Next page
Qualifying Cabling with the Autotest
25
Wiremap Results
avv16f.eps
avv17.bmp
(a)
avv18.bmp
(b)
A Adapter type and number (wiremap adapter
as shown, or remote ID locator).
B Overall result for the wiremap (pass F, fail f ,
informational ?). See Figure 9.
C Wiremap. This example shows a good
wiremap with a wiremap adapter connected.
Open on pin 3 with (a) and without (b) a far-end adapter. The open is
before the middle of the cabling.
With an adapter, the tester identifies which wire in the pair is open.
Without an adapter, only the pair with the open is identified.
The wiremap diagrams are proportional to the cabling tested. For
example, if a wire is open halfway down the cable, the open appears
in the middle of the wiremap diagram.
-continued-
Figure 10. Typical Wiremap Screens
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke networks CableIQ at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke networks CableIQ in the language / languages: English as an attachment in your email.

The manual is 1.07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info