775832
68
Zoom out
Zoom in
Previous page
1/98
Next page
190 Series III
Users Manual
62
Motor Drive Input
The Motor Drive Input functions check the drive input conditions. Input voltage relates to the
quality of the mains power that feeds the drive. Input current depends on the loading of the drive
and the condition of the drive input section.
Voltage and Current
Voltage and Current measurements check for supply voltage, current, and frequency at the Motor
Drive input.
The measurement is done on one of the phases and for 3-phase systems can be repeated for the
other phases. Voltage measurements between two phases (Phase-Phase) or between phase
and ground (Phase-Ground) is selected in the submenu.
The display shows the voltage waveform in red and the current waveform in blue. The rms
voltage, rms current and frequency are displayed as readings in the top of the display.
For displayed readings, use 2 to change to the Volt Peak readings or Current Peak
readings: Peak-Peak, Maximum Peak, Minimum Peak as well as the Crest Factor (ratio between
peak and rms value). This only changes the readings. The voltage and current waveform
continue to show on the display with no change.
Tips:
The test tool can compare the rms voltage against the intended nominal voltage. The Vrms
should be ±10 % of the intended voltage.
If the voltage is out-of-range:
Check if the local circuit is overloaded.
Check if the load of the circuit matches the current rating of the circuit breaker. A high
current load can result in a low voltage on the drive input.
Check the sizing of the conductor feeding the circuit to see whether the cable size is
within specifications compared to local requirements.
If the voltage is ±10 % of intended voltage, the voltage level is not the problem during the
measurement period. Certain conditions can cause the voltage to go outside of the
acceptable limits during other time periods.
68


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke MDA-550-III at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke MDA-550-III in the language / languages: English as an attachment in your email.

The manual is 9.23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info