763944
118
Zoom out
Zoom in
Previous page
1/134
Next page
8588A/8558A
Operators Manual
114
To better understand the Initiate settings, see the equivalent SCPI remote
commands in Table 24.
Table 24. SCPI Initiate Commands
Command Action
INITiate:CONTinuous ON
When the current trigger cycle is complete, the Trigger subsystem
immediately commences another trigger cycle without entering the
Idle state. If the system is in the idle state when Continuous is set
to ON, the idle state is immediately exited and the system
traverses to the ARM2 layer.
INITiate:CONTinuous OFF
When the current trigger cycle is complete the subsystem enters
the Idle state. The Trigger subsystem remains in the Idle state until
the command INIT:IMM is sent.
INITiate:EPOCh start>, <stop>
Continuous ON occurs at <start> date and time.
Continuous OFF occurs at <stop> date and time.
INITiate:IMMediate
This command causes exit from the Idle state. One full trigger
cycle is completed returning to Idle on completion. If the Trigger
subsystem is not Idle or if Continuous is set to ON, error -213 is
generated.
The next three rows in Extended Settings control the parameters in the Arm2,
ARM1, and Trigger layers. Each of the parameters in Arm2 and Arm1 are
identical to the Trigger layer (described above) with the exception of Holdoff
which is available in the Trigger layer only.
The last two rows of Extended Settings are Signal level and Ext Trig Type. Signal
level parameters are applicable when the trigger event is set to Internal. Ext Trig
Type parameters are applicable when the trigger event is set to External. The
Signal level and Ext Trig parameters can be set in any layer but will always be
the same for all layers.
118


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 8558A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 8558A in the language / languages: English as an attachment in your email.

The manual is 1,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fluke 8558A

Fluke 8558A User Manual - German - 134 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info