764336
81
Zoom out
Zoom in
Previous page
1/130
Next page
Documenting Process Calibrator
Process Instrument Calibration
69
Process Instrument Calibration
Note
To calibrate a HART-capable transmitter using the
built-in HART interface, see the 754 HART Mode
Users Guide for instructions.
When the Product is in MEASURE/SOURCE, a built-in
calibration routine can be configured when the As Found
softkey is pushed. As Found data is the test results that
show the condition of a transmitter before it is adjusted. The
Product can run preloaded tasks that are developed with a
host computer and DPCTrack2 application software. See
“Communication with a PC”.
Generate “As Found” Test Data
The subsequent example shows how to supply as
found data for a thermocouple temperature transmitter.
Here, the Product simulates the output of a thermocouple
and measures the current regulated by the transmitter.
Other transmitters use this same procedure. Go back to
MEASUREMENT or SOURCE mode and change the
operation parameters before you push As Found.
1. Connect the test leads to the instrument under test as
shown in Figure 30. The connections simulate a
thermocouple and measure the corresponding output
current.
2. If necessary, push for MEASURE mode.
3. Push .
4. Push for SOURCE mode.
5. Push t and to select TC sensor.
6. Push and to select the thermocouple type.
7. Push to select then to select Linear T source
mode.
8. Record a source value, for example 100 degrees, and
then push .
81


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 754 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 754 in the language / languages: English as an attachment in your email.

The manual is 5,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fluke 754

Fluke 754 User Manual - German - 130 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info