764336
41
Zoom out
Zoom in
Previous page
1/130
Next page
Documenting Process Calibrator
Measure Mode
29
5. The ID string is shown at the bottom of the boxed area.
To erase a character, push the Back Space softkey. To
erase the complete string, push . Information
recorded in the ID string is recorded with all
measurements stored in memory.
6. Push , , , or to select a character, then push
. Use the numeric keypad to record numbers.
7. Do step 6 until satisfied with the ID string.
8. Push the Done softkey.
9. Push the Done softkey or s to exit Setup mode.
Measure Mode
Note
To get the best noise rejection and highest
accuracy performance when you measure, use the
battery; do not use the battery charger.
The operation mode (for example, MEASURE, SOURCE) is
shown in the top left of the display. If the Product is not in
MEASURE mode, push until MEASURE is shown. The
Product must be in MEASURE mode to change the
MEASURE parameters.
Measurement Ranges
The Product usually changes to the correct measurement
range automatically. The lower left side of the display shows
“Range” or “Auto” if on the range status. Auto Range switch
points are shown in Specifications. When the Range softkey
is pushed, the range is locked. Push it again to go to and
lock on the next higher range. Auto Range is in operation
when a different measurement function is selected.
If the range is locked, overrange inputs show on the
display as - - - - - -. In Auto Range, out of range is
shown as ! ! ! ! ! !.
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 754 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 754 in the language / languages: English as an attachment in your email.

The manual is 5,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fluke 754

Fluke 754 User Manual - German - 130 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info