764331
11
Zoom out
Zoom in
Previous page
1/36
Next page
Pressure Calibrator with Electric Pump
Introduction
3
Make sure the battery door is closed and
latched before operating the Calibrator.
Do not operate the Calibrator if it is
damaged.
Do not operate the Calibrator around
explosive gas, vapor, or dust.
When using probes, keep fingers behind
the finger guards on the probes.
Use only two 9 V batteries, properly
installed in the Calibrator case, to power
the Calibrator.
Follow all equipment safety procedures.
Turn off circuit power before connecting
the Calibrator mA and COM terminals in
the circuit. Place Calibrator in series with
the circuit.
When servicing the Calibrator, use only
specified replacement parts.
Do not allow water inside the case.
To avoid false readings, which could
lead to possible electric shock or
personal injury, replace the battery as
soon as the battery indicator (B)
appears.
To avoid a violent release of pressure in
a pressurized system, shut off the valve
and slowly bleed off the pressure before
attaching or detaching the internal
pressure sensor or pressure module
fitting to the pressure line.
To avoid over pressure damages, do not
apply pressure that exceeds the limits
listed in the Pressure Specifications
table in the Specifications section.
To avoid mechanically damaging the
Calibrator, do not apply torque between
the pressure fitting and the Calibrator
case. See Figure 1 for the proper use of
tools.
To avoid misleading readings,
disconnect the pressure module
connector at the Calibrator.
To avoid damage to the pressure
module, refer to the related Instruction
Sheet.
To avoid damage to the pump, use with
dry air and non-corrosive gases only.
Check test leads for continuity before
using. Inspect Calibrator for cracks or
damage, do not use the probes if they
are damaged or show high resistance.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 719 Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 719 Series in the language / languages: English as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fluke 719 Series

Fluke 719 Series User Manual - German - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info