775825
8
Zoom out
Zoom in
Previous page
1/98
Next page
190 Series III
Users Manual
2
The MDA-550-III Motor Drive Analyzer is an extension of the ScopeMeter® Test Tool 190 Series
III with additional functionality and accessories that test inverter type motor drives. Inverter type
motor drives are known as variable frequency drives or variable speed drives and use pulse
width modulation to control ac motor speed and torque. The test tool supports motor drives with
signal levels up to 1000 V to ground.
For Motor Drive Analysis, the test tool provides:
Key motor drive parameters
Includes measurement of voltage, current, dc link voltage level and ac ripple, voltage and
current unbalance, harmonics, and voltage modulation.
Extended harmonics
Identifies the effects of low and high order harmonics on the electrical power system.
Guided measurements
Guidance for motor drive input, dc bus, drive output, motor input, and shaft measurements.
Simplified measurement setup
Graphically shows how to connect and then automatically triggers according to the selected
test procedure.
Reports
Use for troubleshooting and collaborative work with others.
Additional electrical parameters
Full 500 MHz oscilloscope capability is available for the complete range of electrical and
electronic measurement on industrial systems.
The TrendPlot function in the Recorder mode plots a graph of selected Motor Drive readings over
time.
Replace all references to the Meter key in the Users Manual with the Motor Drive Analyzer key. It
is not possible to show large readings as described in the section Automatic Meter
Measurements (190-xx4). However, it is possible to show readings together with the waveform as
described in the section Automatic Scope Measurements.
The Motor Drive Analyzer is based on the ScopeMeter test tool model 190-504. All references to
models 190-xx2 can be ignored.
The accessory set that is included for the Motor Drive Analyzer is different than the ScopeMeter®
Test Tool 190 Series III. See Tabl e 2.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 190-062-III at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 190-062-III in the language / languages: English as an attachment in your email.

The manual is 9.23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info