775836
58
Zoom out
Zoom in
Previous page
1/62
Next page
1773/1775/1777
Users Manual
52
An RVC Event is detected when the arithmetic mean of 100/120 URMS(1/2) values falls outside
the an RVC threshold. When a voltage change crosses the dip or swell thresholds, it is
considered a dip or swell and not a rapid voltage change. The event list shows the voltage step,
transition time, and Vmax. See Tab l e 1 2.
Parameters to configure:
Trigger on/off
Limit
The voltage Threshold limit value is defined as % of nominal voltage. The values is typically
in the range of 1 % to 6 %. The RVC hysteresis shall be less than the RVC threshold and is
typically 50 % of the RVC.
Waveform Deviation. The Waveform Deviation trigger monitors the differences in the
waveforms of consecutive voltage cycles. Each sample magnitude of the last cycle is
compared with the sample magnitude of the actual cycle. The trigger starts when the
difference exceeds the configured limit and ends when the difference is lower than the
threshold minus the hysteresis. If a waveform deviation triggers starts within one second after
the previous waveform deviation trigger ended, it is combined to one event.
Table 12. Rapid Voltage Change Characteristics
Voltage URMS
Voltage-to-steady-state logic
signal
Changes in voltage-to-steady-
state logic signal are disabled
RVC threshold
Arithmetic mean of the previous
100/200 URMS(%) values
Dip threshold
Steady-state
 100/200 URMS(%)
RVC event duration
RVC threshold with hysteresis
applied
URMS(%) values
ΔUss
ΔUMAX
Time
A
B
C
D
E
F
J
G
H
I
K
L
M
N
O
58


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 1777 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 1777 in the language / languages: English as an attachment in your email.

The manual is 3.36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info