775836
51
Zoom out
Zoom in
Previous page
1/62
Next page
3 Phase Power Quality Analyzer
Glossary
45
Harmonics Calculation Method. Select the harmonic calculation method to apply according to
IEC 61000-4-7. The Analyzer applies a FFT (Fast Fourier Transformation) every 10/12 cycles
(typical 200 ms), that delivers spectral components (bins) every 5 Hz from dc up to ½ fs. The
‘fs’ is the sample frequency of the A/D converter, for example, 10.24 kHz. The standard allows
three different ways to calculate the harmonics from these 5 Hz components: Harmonic
Components, Harmonic Sub-Groups, and Harmonic Groups. See Table 8.
Note
Most power quality standards, such as EN 50160, GOST 33073 refer to
IEC 61000-4-30 Class A measurement methods that require Harmonic Sub-Groups.
Table 8. Overview
Harmonics Interharmonics
Harmonic Components
(required for measurements
according to certain standards, such
as IEEE519 or IEC 61000-3-12) RMS value of a single 5 Hz
component
RMS value of all bins
between two
harmonics
Sub-Grouped Harmonics (default)
(for IEC 61000-4-30 compliant
measurements, such as EN50160) RMS value of the
harmonic frequency and
adjacent bins
RMS value of all bins
between two
harmonics
Grouped Harmonics RMS value of the
harmonic frequency and
½ of the interharmonic
spectrum to both sides
not available
51


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 1777 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 1777 in the language / languages: English as an attachment in your email.

The manual is 3.36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info