775835
62
Zoom out
Zoom in
Previous page
1/62
Next page
1773/1775/1777
Users Manual
56
Inrush Current. Inrush currents are surge currents that occur when a large or low-impedance
load comes on line. Normally the current will stabilize after some time when the load has
reached normal working condition. For example, the start-up current in induction motors can
be 10x the normal working current. See Table 1 5 . The inrush current begins when the
½-cycle RMS current rises above the inrush threshold, and ends when the ½-cycle RMS
current is equal to or below the inrush threshold minus the hysteresis value. In the event table,
the extreme value is the highest ½-cycle RMS value of the event.
Parameters to configure:
Trigger on/off
Limit
The current threshold limit is the ½ cycle RMS value in A. A signal exceeding this limit
triggers the event.
Table 15. Inrush Characteristics
Threshold (=Trigger)
Hysteresis
Duration
AB
}
C
62


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 1775 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 1775 in the language / languages: English as an attachment in your email.

The manual is 3.36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info