775834
61
Zoom out
Zoom in
Previous page
1/62
Next page
3 Phase Power Quality Analyzer
Glossary
55
Trigger sensitivity
This sets the voltage level of the spectral component of the input signal above 1.5 kHz.
Predefined settings of low-medium-high for the trigger level allow an easy configuration
based on the required trigger sensitivity, where low is the most sensitive setting. You can
configure a custom setting when the session should, for example, store only events >500V.
Mains Signaling. Power distribution systems can carry control signals to remotely switch on
and off appliances (also known as ripple control). The control signals are present only at the
moments that a remote appliance has to be controlled. The Mains Signaling trigger can
capture the occurrence (signal level) of control signals with 2 different frequencies.
Parameters to configure:
Trigger on/off
Mains Signaling Voltage (MSV) frequency 1 and MSV frequency 2 in Hz
Frequency range is 100 Hz up to 3000 Hz
Limit
The voltage threshold limit value is defined as % of nominal voltage. The value is typically in
the range of 1 % to 5 %.
Recording time
The event triggers a 10/12 cycle recording of up to 120 s.
61


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 1773 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 1773 in the language / languages: English as an attachment in your email.

The manual is 3.36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info