634650
17
Zoom out
Zoom in
Previous page
1/96
Next page
12
FBK 4 B2
GB
IE
Before use
CAUTION!
Please pay attention to the statutory provisions in the relevant noise
protection regulations.
Before starting the appliance, always check that:
The fuel system is not leaking.
The protective equipment and cutting equipment is complete and in
perfect working order.
All screw connections are firmly tightened.
All moving parts can move smoothly and freely.
Starting when the engine is cold
CAUTION!
Never allow the starter pull cord to whip back This could cause
damage.
1.) Fill the fuel tank
(see also the section "Fuel and oil").
2.) Press the primer
6 times.
3.) Switch the on/off switch
to "I".
4.) Pull the choke lever
into position " ".
5.) Hold the appliance firmly and pull out the starter pull cord
to the
point of first resistance. Now pull hard on the starter pull cord
.
The appliance starts.
6.) If the engine does not start, repeat steps 4–5.
7.) As soon as the engine is running, press the safety lock-out
and then
press the throttle
to activate the automatic choke.
If the engine does not start after several attempts, read the "Troubleshoot-
ing guide" section.
CAUTION!
Always pull the starter pull cord
straight out. Hold the handle of
the starter pull cord
firmly when the starter pull cord retracts.
Do not allow the starter pull cord
to whip back.
NOTE
At very high ambient temperatures it is possible that even a cold
engine has to be started without using the choke!
Starting when the engine is hot
(The appliance has been turned off for less than 15–20
minutes)
1.) Switch the on/off switch
to "I".
2.) The choke lever
does not need to be pulled out to start a warm motor.
3.) Hold the appliance firmly and pull out the starter pull cord
to the
point of first resistance. Now pull hard on the starter pull cord
.
The appliance should start after 1–2 pulls. If the appliance still hasn't
started after 6 pulls, repeat steps 1–7 under "Starting when the engine
is cold".
Turning the engine off
Emergency stop sequence
If you need to stop the appliance immediately, switch the on/off switch
to "0".
Normal sequence
Release the throttle lever
and wait until the engine has slowed down
to its idling speed. Then switch the on/off switch to "0".
CAUTION!
The 3-section cutting blade must be stationary when the engine is
idling. If the 3-section cutting blade is rotating adjust the carburettor!
Optimal working procedures
Before using the appliance, practice all working techniques (see Figs.
6a–6c) with the engine stopped.
Extending the cutting Strimmer cord
To lengthen the cutting Strimmer cord, rev the engine to full throttle and tap
the strimmer
on the ground. The Strimmer cord extends automatically.
The knife
A
on the cutting Strimmer cord protective guard
C
cuts the
thread to the permissible length (see Fig. 6d).
CAUTION!
Grass/weed residues can get caught under the protective guard
.
Remove the remains using a scraper or similar item when the engine
is switched off.
Various cutting methods
Trimming/mowing (3-section cutting blade or strimmer)
Swing the appliance in a scything motion (see Fig. 6a).
Hold the cutting tool parallel to the ground and set the desired cutting
height.
Low trimming (with strimmer)
Hold the appliance with a slight incline to the ground (see Fig. 6b). Al-
ways cut away from your body. Never pull the appliance towards you.
Short mowing (with strimmer)
Short mowing removes all the vegetation right down to the ground.
Angle the strimmer 30° to the right. Set the handle to the desired
position (see Fig. 6c).
Cutting against trees/fences/foundations (with strimmer)
NOTE
The Strimmer cord will wear or fray quickly if it comes into contact
with trees, rocks, walls or foundations. The Strimmer cord will break
off if it strikes fence mesh.
CAUTION!
Do not use the appliance to remove any objects from footpaths, etc.!
The appliance is powerful and can fling small stones or other objects
15 metres or more and may cause injuries or damage to cars,
houses and windows.
Wear safety goggles!
Jamming
Immediately turn off the engine if the cutting tool becomes blocked.
Remove all grass and scrub from the appliance before restarting the
appliance.
Preventing kickback
When working with the cutting blade there is a risk of kickback if the blade
strikes against solid obstacles (tree trunks, branches, tree stumps, rocks or
similar). This will result in the cutting tool being catapulted back against the
direction of rotation. This can lead to the loss of control of the appliance.
Do not use the cutting blade near fences, metal posts, boundary stones or
foundations. To cut weak shrubs, position the appliance as shown in Fig.
6e to avoid kickbacks.
17


Need help? Post your question in this forum.

Forumrules
1

Forum

florabest-fbk-4-b2---4-in-1--ian-273489

Reset search

  • Bonjour,
    J'ai une débroussailleuse Parkside FBK 4 B2-1 dont le bouton du starter est cassé. Je cherche donc un filtre à air compatible. Je cherche aussi une nouvelle tête pour le roto-fil.
    Pouvez-vous me donner les prix et délai. Merci
    Cordialement Submitted on 19-8-2022 at 11:21

    Reply Report abuse
  • Looking we’re to buy new choke lever for florabest FBK 4 B2 Submitted on 25-11-2021 at 15:07

    Reply Report abuse
  • Bonjour je recherche un arbre de transmission florabest ref fkb4 b2 Submitted on 14-7-2021 at 20:52

    Reply Report abuse
  • BONJOUR JE CHERCHE LES EMBOUT POUR LES RALONGES ET OUTILS 4 EN 1 DE LA DEBROUSAILLEUSE FLORABEST FBK 4 B2-1
    NUMERO DES MANCHON 5010259201 Submitted on 19-5-2020 at 11:45

    Reply Report abuse
  • I need a recoil starter unit and pawl for FBS 25 A1 / IAN 280454 multi tool can anyone tell me where I can get them from Submitted on 18-5-2020 at 17:31

    Reply Report abuse
  • New choke leaver for florabest multi strimmer fbk-ebb -1 s/n081439 Submitted on 30-3-2020 at 16:09

    Reply Report abuse
  • Engine is turning first through first section but will not drive any of the attachments
    Maynard Submitted on 12-7-2019 at 00:42

    Reply Report abuse
  • Machine has worked fine for 2 years. Now will not start. Have changed fuel that was in the tank, changed spark plug, cleaned air filter, still no joy. Doesn't even sound as if it wants to start. Any ideas or suggestions ?
    Desperate Den. Submitted on 26-2-2019 at 16:16

    Reply Report abuse
    • The part that produces the spark when you pull the cord went faulty with mine,and required replacement. Unfortunately I cannot remember what it is called. Hope this helps. Answered on 28-2-2019 at 16:55

      Vote up Report abuse
    • Thanks for your input, gives me a new avenue to explore. Answered on 28-2-2019 at 21:11

      Vote up Report abuse
    • You could check if the plastic pipe into the tank has broken and dropped off inside. This will not be obvious when you open the lid because part of it will still be attached to the engine. Answered on 10-10-2020 at 15:14

      Vote up (1) Report abuse
  • Fuel doesn't appear to be supplying the engine. When the unit is on its side it idles but when I put it upright it cuts out. Submitted on 27-5-2017 at 14:11

    Reply Report abuse
    • I had that problem and it was the small tube coming from the fuel tank that was split just inside the tank. Answered on 8-5-2020 at 10:40

      Vote up Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Florabest FBK 4 B2 - 4 in 1 IAN 273489 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Florabest FBK 4 B2 - 4 in 1 IAN 273489 in the language / languages: Dutch, Danish as an attachment in your email.

The manual is 3,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Florabest FBK 4 B2 - 4 in 1 IAN 273489

Florabest FBK 4 B2 - 4 in 1 IAN 273489 User Manual - English, German, French, Italian - 78 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info