634650

Florabest FBK 4 B2 - 4 in 1 IAN 273489 Manual

73
Zoom out
Zoom in
Previous page
1/78
Next page
68
FBK 4 B2
GB
Cleaning the hedge trimmer
♦ Check the hedge trimmer for loose screws on the cutter bar
and
tighten these if necessary.
♦ Remove stuck cuttings.
♦ Maintain the cutter bar
using an oil spray or an oil can.
Cleaning the strimmer/3-section cutting blade attachment
♦ Remove stuck cuttings.
♦ Keep the 3-section cutting blade
sharp to facilitate your work.
Maintenance
Replacing the strimmer/cutting Strimmer cord
1.) The strimmer
is removed as described in the section Installing/
replacing the strimmer. Press the marking (see Fig. 5a), turn the cover
and remove one half of the casing (see Fig. 5b).
2.) Remove the spool bobbin
from the strimmer housing (see Fig. 5c).
3.) Remove any remaining cutting Strimmer cord.
4.) Double the new cutting Strimmer cord in the middle and hook the loop
that you have made into the recess on the spool bobbin (see Fig. 5d).
5.) Wind the Strimmer cord tightly in an anticlockwise direction. The spool
bobbin
separates the two halves of the cutting Strimmer cord (see
Fig. 5d).
6.) Hook the last 15cm of the two ends of the Strimmer cord into the
opposite Strimmer cord holders
(see Fig. 5e).
7.) Guide the two ends of the Strimmer cord through the metal lugs in the
strimmer housing (see Fig. 5e).
8.) Press the spool bobbin
into the strimmer housing (see Fig. 5e).
9.) Reconnect the two halves of the housing.
10.) Pull hard on the two ends of the Strimmer cord to free them from the
Strimmer cord holders (see Fig. 5f).
11.) Cut any excess Strimmer cord back to about 13 cm. This reduces the
load on the engine when starting and warming up.
12.) Refit the strimmer (see section "Installing/replacing the strimmer").
Skip points 3–6 if you are replacing the entire strimmer.
Air filter maintenance
Contaminated air filters reduce the engine performance due to low air
supply to the carburettor.
Regular inspection is essential. The air filter
must be inspected after
every 25 hours of operation and cleaned if necessary.
The air filter must be checked more frequently if the air is dusty.
1.) Remove the cover of the air filter housing
.
2.) Remove the air filter
.
3.) Clean the air filter
by tapping or blowing it out (with compressed
air).
4.) Assembly takes place in the reverse order.
CAUTION!
■ Never clean the air filter with petrol or flammable solvents.
Spark plug maintenance
1.) Pull off the spark plug connector
.
2.) Unscrew the spark plug using the spark plug wrench
6&
supplied.
3.) Assembly takes place in the reverse order.
Electrode gap = 0.6 mm (distance between the electrodes between which
the ignition spark is generated). Check the spark plug for contamination
after the first 10 hours of operation and clean it with a copper wire brush
if required.
Afterwards, service the spark plug after every 50 hours of operation.
Grinding the protective guard blade
The blade
A
(see Fig. 2a) can become blunt over time. If you find this
to be the case, undo the 2 screws that hold the blade
A
onto the cutting
Strimmer cord protective guard
C
. Clamp the blade
A
in a vice. Grind
the blade
A
with a sharpening stone and make sure you maintain the
angle of the cutting edge.
Adjusting the carburettor
Remove the cover of the air filter housing
.
Adjusting the throttle cable
If the appliance no longer reaches maximum speed after a while and all
other causes as described in the "Troubleshooting" section have been ruled
out, this may mean that the throttle cable needs to be adjusted. To adjust
the throttle cable, screw in the screw
or the adjusting screw
H1
as well
as the lock nut
H2
correctly (see Fig. 4).
Lubricating the gears
■ Add liquid gear grease after every 20 hours of operation (approx. 10 g)
to lubricate the angle gear.
♦ To do this, undo the screw (see foldout page) to press the gear
grease into the gear housing.
♦ After filling the gearbox, close the lubrication hole with the screw
.
Storage and transportation
■ Store the appliance in a safe location.
■ Store the appliance and accessories in a safe location which is
protected against naked flames and sources of heat/sparks, such as
gas-powered water heaters, dryers, oil stoves or mobile heaters, etc.
■ Ensure that the protective guard
, the strimmer and the engine are
free of cutting residue when storing.
■ The plastic cover for the 3-section cutting blade
must be refitted for
transport and storage.
■ Always turn the appliance off before performing any maintenance work
and remove the spark plug connector
.
Storing the appliance
The appliance must be prepared for storage if it is to be stored for longer
than 30 days. Otherwise the residual fuel in the carburettor will evaporate
and leave a gooey sediment. This may make starting the appliance more
difficult and result in expensive repair work.
1.) Remove the filler cap
to relieve any pressure in the fuel tank .
Carefully empty the fuel tank
.
2.) To remove all fuel from the carburettor, start the engine and leave it to
run until it stops.
3.) Allow the engine to cool for about 10 minutes.
4.) Remove the spark plug (see section "Spark plug maintenance").
… 73 …


Need help? Post your question in this forum.

Forumrules
1

Forum

florabest-fbk-4-b2---4-in-1--ian-273489

Reset search

  • Bonjour,
    J'ai une débroussailleuse Parkside FBK 4 B2-1 dont le bouton du starter est cassé. Je cherche donc un filtre à air compatible. Je cherche aussi une nouvelle tête pour le roto-fil.
    Pouvez-vous me donner les prix et délai. Merci
    Cordialement Submitted on 19-8-2022 at 11:21

    Reply Report abuse

  • Looking we’re to buy new choke lever for florabest FBK 4 B2 Submitted on 25-11-2021 at 15:07

    Reply Report abuse

  • Bonjour je recherche un arbre de transmission florabest ref fkb4 b2 Submitted on 14-7-2021 at 20:52

    Reply Report abuse

  • BONJOUR JE CHERCHE LES EMBOUT POUR LES RALONGES ET OUTILS 4 EN 1 DE LA DEBROUSAILLEUSE FLORABEST FBK 4 B2-1
    NUMERO DES MANCHON 5010259201 Submitted on 19-5-2020 at 11:45

    Reply Report abuse

  • I need a recoil starter unit and pawl for FBS 25 A1 / IAN 280454 multi tool can anyone tell me where I can get them from Submitted on 18-5-2020 at 17:31

    Reply Report abuse

  • New choke leaver for florabest multi strimmer fbk-ebb -1 s/n081439 Submitted on 30-3-2020 at 16:09

    Reply Report abuse

  • Engine is turning first through first section but will not drive any of the attachments
    Maynard Submitted on 12-7-2019 at 00:42

    Reply Report abuse

  • Machine has worked fine for 2 years. Now will not start. Have changed fuel that was in the tank, changed spark plug, cleaned air filter, still no joy. Doesn't even sound as if it wants to start. Any ideas or suggestions ?
    Desperate Den. Submitted on 26-2-2019 at 16:16

    Reply Report abuse

    • The part that produces the spark when you pull the cord went faulty with mine,and required replacement. Unfortunately I cannot remember what it is called. Hope this helps. Answered on 28-2-2019 at 16:55

      Vote up Report abuse

    • Thanks for your input, gives me a new avenue to explore. Answered on 28-2-2019 at 21:11

      Vote up Report abuse

    • You could check if the plastic pipe into the tank has broken and dropped off inside. This will not be obvious when you open the lid because part of it will still be attached to the engine. Answered on 10-10-2020 at 15:14

      Vote up (1) Report abuse

  • Fuel doesn't appear to be supplying the engine. When the unit is on its side it idles but when I put it upright it cuts out. Submitted on 27-5-2017 at 14:11

    Reply Report abuse

    • I had that problem and it was the small tube coming from the fuel tank that was split just inside the tank. Answered on 8-5-2020 at 10:40

      Vote up Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Florabest FBK 4 B2 - 4 in 1 IAN 273489 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Florabest FBK 4 B2 - 4 in 1 IAN 273489 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 3,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Florabest FBK 4 B2 - 4 in 1 IAN 273489

Florabest FBK 4 B2 - 4 in 1 IAN 273489 User Manual - Dutch, Danish - 96 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info