791808

FlinQ FQC8230 - Luxxtree Manual

9
Zoom out
Zoom in
Previous page
1/11
Next page
9
① ② ③ ④ ⑤
EN 3) Carefully pull the light cord upwards into the agpole, making sure that the 2 ends (side A + side B) of the light cord are
attached to each other in steps of 10. This is done with the supplied strips. Do not fasten the strips too tightly. If necessary,
cut off the protruding strip to achieve a better result.
NL 3) Hijs het lichtsnoer voorzichtig de vlaggenmast op, en zorg ervoor dat de 2 uiteinden (zijde A + zijde B) van het lichtsnoer
gefaseerd, in stappen van 10, aan elkaar worden bevestigd. Dit middels de bijgeleverde strips. Maak de strips niet te strak
vast. Knip, indien nodig, de overtollige strip af voor een mooier resultaat.
DE 3) Ziehen Sie die Lichterkette vorsichtig am Fahnenmast hoch und achten Sie darauf, dass die 2 Enden (Seite A + Seite B )
des Lichtkabels werden in 10er-Schritten aneinander befestigt. Dies geschieht mit den mitgelieferten Streifen. Befestigen
Sie die Streifen nicht zu stramm. Schneiden Sie ggf. den überstehenden Streifen ab, um ein besseres Ergebnis zu erzielen.
FR 3) Tirez délicatement le cordon lumineux vers le haut dans le mât, en veillant à ce que les 2 extrémités (côté A + côté B) du
cordon lumineux soient attachées l’une à l’autre par pas de 10. Cette opération s’effectue à l’aide des bandes fournies.
Ne xez pas les bandes trop serrées. Si nécessaire, coupez la bande qui dépasse pour obtenir un meilleur résultat.
IT 3) Tirare con attenzione la corda luminosa verso l’alto nell’asta della bandiera, facendo assicurandosi che le 2 estremità (lato
A + lato B) del cavo luminoso siano attaccate l’una all’altra a passi di 10. Questo viene fatto con le strisce in dotazione.
Non ssate le strisce troppo strettamente.
ES 3) Tire con cuidado de la cuerda de luces hacia arriba en el asta, asegurándose de que los dos extremos (lado A + lado B) de
la cuerda de luces estén bien ajustados asegurándose de que los dos extremos (lado A + lado B) del cordón luminoso están
unidos entre sí en pasos de 10. Esto se hace con las tiras suministradas. No apriete demasiado las tiras.
① ② ③ ④ ⑤
EN 4) Use a piece of rope or a tape measure with the length of 127,5 cm to measure from the agpole and straight out in
different 8 points around the ground spear. Place a ground peg to mark the spot. we recommend placing the pegs opposite
each other as shown in the drawing.
… 9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for FlinQ FQC8230 - Luxxtree at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of FlinQ FQC8230 - Luxxtree in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1.96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info